Single-Bit Comparator in Quantum-Dot Cellular Automata (QCA) Technology Using Novel QCA-XNOR Gates

来源 :电子科技学刊 | 被引量 : 0次 | 上传用户:heyouzhang035
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
To fill the continuous needs for faster processing elements with less power consumption causes large pressure on the complementary metal oxide semiconductor (CMOS) technology developers. The scaling scenario is not an option nowadays and other technologies need to be investigated. The quantum-dot cellular automata (QCA) technology is one of the important emerging nanotechnologies that have attracted much researchers\' attention in recent years. This technology has many interesting features, such as high speed, low power consumption, and small size. These features make it an appropriate alternative to the CMOS technique. This paper suggests three novel structures of XNOR gates in the QCA technology. The presented structures do not follow the conventional approaches to the logic gates design but depend on the inherent capabilities of the new technology. The proposed structures are used as the main building blocks for a single-bit comparator. The resulted circuits are simulated for the verification purpose and then compared with existing counterparts in the literature. The comparison results are encouraging to append the proposed structures to the library of QCA gates.
其他文献
准确高效求解非正弦条件下的磁损耗,对电工装备发热分析及优化设计具有重要意义.为了研究脉冲宽度调制(pulse width modulation,PWM)激励下铁磁材料的磁损耗建模方法,通过搭建磁通密度可控的PWM激励磁特性测试系统,测量获得不同工况下硅钢片的磁滞特性和损耗特性数据,并分析PWM激励的特征(电压波形、磁密波形、调制比)对损耗各分量的影响.同时,结合PWM激励时材料磁滞过程的分析,考虑电压突变为零时松弛过程对剩余损耗的影响,提出一种计及PWM激励特征及松弛过程的改进损耗分离模型,实现PWM激励
换流变压器的阀侧绝缘主要承受交直流复合电压,这种电压所引起的局部放电与纯交流或纯直流电压所引起的明显不同.基于流体动力学漂移–扩散方程和双极性电荷传输方程的仿真模型能反映电场强度和电荷密度的分布,所以局部放电的产生和发展能被有效描述.该文首先用实验结果验证仿真理论的可行性,然后建立纸板因电老化而存在凹陷的仿真模型,并先后施加多种交直流复合电压.不仅研究了沿面放电在凹陷中的形成和发展过程,还探讨了瞬时电压、几何参数、电压比例和介电常数等因素的变化对局部放电的影响.对沿面放电的研究能部分揭示换流变压器阀侧局部
A terahertz dual-mode extended interaction oscillator (EIO) driven by a pseudospark-sourced sheet electron beam (SEB) was presented.The major advantages of the newly developed circuit include 1) high-density SEB interacting with the TM11 and TM
针对五相永磁同步电机(permanent magnet synchronous motor,PMSM)开路故障导致转矩脉动大的问题,提出一种基于新型开关表的容错直接转矩控制(direct torque control,DTC)策略.首先,修正定子磁链以保持开路故障前后定子磁链矢量在两相静止坐标系中具有相同的圆形轨迹.其次,根据故障情况下电压矢量特点,设计新型开关表,确保该开关表同时适用于正常和开路故障情况的DTC运行.该容错DTC策略不但抑制正常和故障情况下的三次电流谐波,避免故障后控制系统的重构,而且抑
模拟高保真的动态风电机叶片雷达回波并提取其多普勒特征,是解决风电场对雷达台站无源干扰的关键问题.针对现有算法均无法准确且实时模拟动态叶片回波的问题,突破采用单一视角的静态散射中心模拟叶片回波的传统思路,将雷达视线下叶片整个旋转周期大转角划分为多个子视角,提出一种基于多视角属性散射中心的动态风电机叶片雷达回波模拟算法.考虑叶片动态旋转中叶片空间姿态对散射中心参量的变化影响,引入属性散射中心模型,采用正交匹配追踪的贪婪算法,提取各雷达视角下动态叶片的属性散射中心;并建立散射中心与叶片运动特征在时间上的对应关系
永磁偏磁型直流限流器(permanent magnet biased saturated core fault current limiter,PMFCL),简称永磁限流器,是一种有效解决柔性直流输电系统短路电流问题的技术手段.传统永磁限流器存在电感变化速度不快、变化倍数较小和永磁体退磁风险问题.针对上述问题,提出一种基于复合磁性材料的永磁偏磁型磁饱和限流器(hybrid soft magnetic material saturated core fault current limiter,HMFCL),
为了提高Ti/PbO2电极的稳定性与催化氧化能力,将化学还原氧化石墨烯(RGO)以共沉积的方法修饰于β-PbO2层.通过扫描电镜(SEM),X射线衍射仪(XRD),循环伏安法(CV),电化学交流阻抗(EIS),产羟基自由基(·OH)能力,强化寿命等测试方法对电极性能进行表征,并以酸性红G(ARG)为目标降解物,评估PbO2-RGO电极的催化效果.结果 表明,电极经RGO改性后晶型仍为β-PbO2,析氧过电位由1.60V升至1.83V,膜阻抗由144 Ω/cm2降至16.2Ω/cm2,强化寿命提升了43.6
The quantitative optical measurement of deep sub-wavelength features with sub-nanometer sensitivity addresses the measurement challenge in the semiconductor fabrication process.Optical scatterings from the sidewalls of patterned devices reveal abundant st
憎水恢复性是硅橡胶复合绝缘子的特有性能,为保持电网输变电设备外绝缘水平和安全稳定运行提供了重要保障.目前,针对复合绝缘子运行放电工况下表面憎水性减弱及恢复特性,缺少快速有效的定量评估方法.该文利用等离子体处理方法模拟复合绝缘子硅橡胶在运行放电工况下憎水性减弱及恢复现象,基于小分子扩散理论和菲克第二定律建立等离子体老化后的硅橡胶表面憎水恢复的动态物理模型,并通过数学推导得出硅橡胶小分子扩散系数D的计算公式.实验发现,仅经过3min的等离子体处理,硅橡胶表面就转变为完全亲水,且小分子在硅橡胶无机硅氧层中的扩散
In this paper, the time domain characters of the response of twisted wire pairs (TWPs) excited by the high-altitude electromagnetic pulse (HEMP) have been proposed. The finite different time domain transmission line model (FDTD-TLM) method, which we have