设计卷扬滚筒,一般是按最大卷扬拉力选定钢丝绳直径,再根据所需钢丝绳长度,计算滚筒直径、毂高和长度。 在此介绍用容积来计算滚筒的方法。 绕满钢丝绳的滚筒轴侧截面如图1(a)所示。放大后的钢丝绳排列如图1(b)。如缠绕层数足够多,则每个钢丝绳截面就对应有一 Design winch drum, generally according to the maximum winding tension selected rope diameter, and then according to the required rope length, calculate the drum diameter, hub height and length. Here is how to calculate the drum volume. The side of the drum shaft wound around the wire rope is shown in Fig. 1 (a). Enlarged wire rope arrangement shown in Figure 1 (b). If the number of winding layers is sufficient, there is one for each section of wire rope