在修理CG1107自动车床的主轴箱时,更换分配轴上的轴承(如图示1、4、10)。由于床身铸件壁很薄,空间位置又很小,不宜用鎯头敲打,这样就给轴套的拆下与装配带来很多困难。为此,我们设计了专门拆装此类轴套的工具。如图示旋转螺母8就能使轴套4拆下,装时用同样方法。拉套板6上钻两个对称孔,用来装两个螺钉可调节拉套板的平行性。(例如拆装轴套10时就需用此方法)。经 When repairing the headstock of the CG1107 automatic lathe, replace the bearings on the distribution shaft (see Figs. 1, 4 and 10). As the bed castings wall is very thin, the space position is very small, should not be used Beijiao head beat, so give the sleeve removed and assembled a lot of difficulties. To this end, we have designed a special tool for the disassembly of such bushings. As shown in the figure, the sleeve 4 can be removed by rotating the nut 8, using the same method. Pull the lashing plate 6 two symmetrical holes drilled, used to install two screws to adjust the parallelism of the lashing plate. (For example, you need this method when disassembling the bushing 10). through