【摘 要】
：
In order to investigate the effect of different B-site additions on phase structure and electrochemical properties of cobalt-free La-Mg-Ni based alloys, La0.80M
【机 构】
：
State Key Laboratory of Metastable Materials Science and Technology,College of Environmental and Che
论文部分内容阅读
In order to investigate the effect of different B-site additions on phase structure and electrochemical properties of cobalt-free La-Mg-Ni based alloys, La0.80Mg0.20Ni2.85Al0.11M0.53 (M=Ni, Si, Cr, Cu, Fe) hydrogen storage alloys were prepared and studied systemati-cally. X-ray powder diffraction showed that the alloys consisted mainly of LaNi3 phase and LaNi5 phase except that Cr addition caused a minor Cr phase. Electrochemical testing indicated that alloys with additional Ni, Cr, Cu or Fe were activated within only 1-2 cycles, while that with Si addition needed 4 cycles. Adding Si, Cu and Fe increased cycling stability of La-Mg-Ni based alloys. However, maximum discharge capacity decreased from 362 mAh/g to 215 mAh/g in the order of Ni>Fe>Cu>Cr>Si. In addition, electrochemical kinetics of alloy electrodes was also researched by measuring high rate discharge ability (HRD), hydrogen diffusion coefficient (D) and limiting current density (IL).
其他文献
A series of Eu2+-doped fluorochlorozireonate glass-ceramics were prepared by solid state reaction method. X-ray diffraction, pho-toluminescence, photo-stimulate
The Gibbs energies of liquid phases in the LaI3-MI (M=Na, K, Cs) systems were described by the modified quasi-chemical model. From the measured phase equilibriu
Ta2O5 thin films were deposited by DC reactive magnetron sputtering followed by rapid thermal annealing(RTA). Influence of sputtering pressure and annealing tem
Antimony-doped tin dioxide(ATO) nanoparticles with primary diameter in the range of 9-10 nm were rapidly synthesized via a novel combustion technique, starting
The thermoluminescence (TL) properties of Ce3+ doped NaSr4(BO3)3 phosphor under the β-ray irradiation were reported. The polycrystalline sample was synthesized
Rare earth sulfides were systematically synthesized via the sulfurization of their commercial oxide powders using CS2 gas to shorten sulfurization time, and the
Zonal heat treatment(ZHT) was conducted in situ to 14.5 mm-thick TC4 alloy plates by means of defocused electron beam after welding. The effects of ZHT on resid
Molecular dynamics (MD) simulations were applied to simulate the deformation process of copper with different density of parallel coherent twin boundaries (TBs)
Research results on the viscous flow deformation behavior of bulk amorphous alloy in different systems are reviewed. The material exhibits an ideal Newtonian fl