【摘 要】
：
We present a kind of large effective aperture metalens based on an optical sparse aperture (OSA) system. Each subaperture of the system is a metalens, which is comprised of just a thin Au film with patterned subwavelength rectangular annular arrays on a S
【机 构】
：
LaboratoryofInformationOpticsandOptoelectronicTechnology,ShanghaiInstituteofOpticsandFineMechanics,C
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
We present a kind of large effective aperture metalens based on an optical sparse aperture (OSA) system. Each subaperture of the system is a metalens, which is comprised of just a thin Au film with patterned subwavelength rectangular annular arrays on a SiO2 substrate and has a numerical aperture of 0.46 with a diameter of 21.6 μm. Ring6 design was selected to enlarge the effective aperture and enhance the spatial resolution. Compared with the absent mid-frequency and high-frequency modulation transfer function of individual metalens, Ring6 can offer a full-frequency band and show a better restored image quality by using Tikhonov regularization.
其他文献
在PHOENICS软件基础上开发了模拟激光表面重熔过程温度场和速度场的数值程序;温度场和速度场的计算采用了固定网格及处理熔化和凝固问题的一般源项方法;移动热源引起的能量和动量变化分别作为附加源项构建控制方程组,采用控制容积积分法对控制方程进行离散和求解;对铝合金激光表面重熔过程中的传热、相变及流体流动问题进行了三维非稳态的数值模拟研究。
We present a novel method for realizing double-image encryption algorithm by combining the images in different transform domains. Two original images are encrypted into two interim images by fractional Fourier transform and gyrator transform, respectively
根据光线追迹原理,研究用于端面抽运的大面阵激光二极管(LD)抽运源的耦合系统设计。结合当前大口径激光二极管阵列常用的空心导管型耦合系统,分别从耦合效率、抽运强度分布、抽运光传输等方面,讨论大口径激光二极管阵列耦合系统的一般设计准则,提出了将激光二极管阵列单元平面排布改为球面排布的办法。针对100 kW激光二极管阵列,将子阵列作球面排布后,仅用一空心导管来汇聚抽运光,这种设计获得了传输性能优良的大区域均匀分布的抽运场,抽运场起伏小于5%,抽运强度大于20 kW/cm2,耦合效率98%,有效抽运区域内效率达9
The design and the early commissioning of the ELI-Beamlines laser facility’s 30 J, 30 fs, 10 Hz HAPLS (High-repetition-rate Advanced Petawatt Laser System) beam transport (BT) system to the P3 target chamber are described in detail. It is the world’s firs
Diode-pumped passively Q-switched Nd:GdVO4/Cr^(4 ):YAG lasers with a simple flat-flat cavity were demonstrated. The maximum average output power at 1.06 μm was 1.25 W. The highest peak power and pulse energy were 7.56 kW and 75 μJ, respectively, with the
利用异靛蓝、丙烯二氧噻吩、噻吩单元组成的供体-受体类型半导体聚合物IPDT构建了有机电子器件Al/IPDT/ITO,该器件具有明显的忆阻特性,开/关电压为8 V/-7.5 V,高低电阻比达到了10 2以上。研究了不同波长激光的照射对器件忆阻性能的影响,结果表明:波长为632 nm、功率为3 mW的激光对忆阻性能的影响显著;照射60 s后,器件电流的走向发生了反转,开/关电压降低到-2.2 V/1.3 V,高低电阻比提高到10 4,电流降低了一个量级,且电流-电压曲线的涨落减小,有效降低了器件的功耗;稳定性
本实验研究表明,犬钢珠枪伤和正常肌肉的光学性质存在着明显的差异,这些差异可作为大钢珠枪伤肌肉坏死界线的判定,因此具有临床应用价值.
周期极化掺镁铌酸锂光参量振荡器(PPMgLN OPOs)是输出高功率、可连续调谐中红外(MIR)激光的理想光源,在激光光谱仪、大气探测、红外信息对抗等应用方面具有很大优势。理论上分析了PPMgLN光参量振荡器的温度调谐特性,计算了脉冲运转单谐振光参量振荡器(SRO)抽运阈值。采用偏振Nd:YAG调Q激光(1064 nm)抽运PPMgLN晶体组成光参量振荡器,抽运阈值功率为1.7 W,与理论计算值接近。当抽运功率为12.3 W时,在波长3.93 μm处获得1.35 W闲频光输出。晶体温度在60-140 ℃范
为提高手机显示屏的耐摩擦、防划伤能力,降低显示屏破碎的风险,研制了在可见光波段的硬质增透膜。通过逐步提高设计中SixNy膜层厚度在薄膜总厚度中所占的比例,优化沉积工艺,改善薄膜硬度。根据增透膜的设计理论、合理的膜层分组方式和逆向反演分析法完成膜系设计,降低了薄膜反射率。测试结果表明,在可见光波段范围内,薄膜的平均反射率为0.58%,硬度达到15.99 GPa。