【摘 要】
：
We experimentally demonstrate a 750 Mb/s real-time visible light communication (VLC) system based on non-return-to-zero on–off keying modulation by employing single commercially available monochromatic light-emitting diodes. To enhance the 3-dB bandwidth
【机 构】
：
KeyLaboratoryofPhotoelectronicImagingTechnologyandSystem,MinistryofEducationofChina,Beijing100081,Ch
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
We experimentally demonstrate a 750 Mb/s real-time visible light communication (VLC) system based on non-return-to-zero on–off keying modulation by employing single commercially available monochromatic light-emitting diodes. To enhance the 3-dB bandwidth of the VLC link, we propose a low-complexity cascaded post-equalizer based on NPN transistors. With two different frequency-selecting networks in our post-equalizer, the highest achieved 3-dB bandwidth of the VLC link is 370 MHz. The highest achieved data rate is 750 Mb/s at a communication distance of 170 cm with a bit error rate below 1×10 6, which is far below the forward error correction limit (3.8×10 3). Based on our monochromatic VLC system, a wavelength-division multiplexing VLC system could be designed with a higher data rate.
其他文献
We report on a power-scalable sub-100-fs laser in the 2-μm spectral range using a Tm3 -doped ‘mixed’ (Lu,Sc)2O3 sesquioxide ceramic as an active medium. Pulses as short as 58 fs at 2076 nm with an average output power of 1
Lidar is an effective tool for remotely monitoring target or object, but the lidar signal is often affected by various noises or interferences. Therefore, detecting the weak signals buried in noises is a fundamental and important problem in the lidar syst
针对图像特征点提取匹配算法中配准率不高的问题,提出了一种优化栅格移动统计的图像配准算法。首先使用快速特征点提取和描述算法提取特征点,再通过暴力匹配算法进行大致的特征点配准。根据图像的大小和特征点的个数将图像划分成多个栅格,对栅格内的特征点数量进行移动统计,通过九宫格里特征点距离中心特征点的远近,使用高斯函数制作分数统计模板。将九宫格里的分数统计与设定的阈值进行对比,超过阈值则认为是一个正确的匹配点
利用GaAs晶体作为可饱和吸收体, 实现了掺镱光子晶体光纤激光器的被动调Q输出。实验用掺杂光子晶体光纤的芯径为21 μm, 数值孔径为0.04, 在实现了大模场面积的同时, 保证了激光器的单模运转, 从而得到高光束质量的激光输出。实验使用高功率半导体激光器作为抽运源, 采用自行研制的耦合系统将抽运光耦合进入光子晶体光纤的包层中。在激光器平均输出功率为5.8 W时, 实验得到的最短输出激光脉冲为80 ns, 重复频率为6.7 kHz。
提出一种基于多个并行Sagnac环梳状滤波器实现波长编码的方法, 可用于孤子自频移全光模数转换的光学编码.仿真结果表明: 该方法在1 601 nm~1 707 nm孤子自频移波段成功实现了5 bits的光学编码, 最大微分线性误差和积分线性误差分别为0.088LSB和0.482LSB.与其他波长编码方式相比, 该方法结构简单、工作波长范围宽, 并且具有非常好的编码位数扩展性.
采用一种新方法,用脉冲CO2激光器获得了掺氢非晶硅薄膜。描述了我们的实验。给出了生长速率与有关实验参数的关系和合适的工作条件;测量和分析了这种薄膜的某些性质。
彩色图像的对比度增强具有较强的工程应用价值,提出了一种简单高效的彩色图像增强算法。该算法基于模糊逻辑理论,配合使用RGB和HSI彩色模型,并依据使对比度变换误差最小的原则,调整灰度变换系数。实验结果表明,该方法的增强效果优于传统的直方图均衡,运行效率高,具有实用价值。
In this Letter, vortex phase and sinusoidal phase modulations of Hermite–Gaussian beams are studied theoretically and experimentally. The coding method of the experiment is introduced in detail, and the evolution law of focus under different beam order (<