近来很多工厂采用了快速焊接法,获得了一定收效,其中尤以多条焊接为最普遍;因为它不需特殊设备,也不如超短弧或深熔焊接法需要特殊焊条才能使用,而仅需增加教目,使几根焊条紧扎起来,成为一束(束状焊条)来代替一根焊条的工作,提高生产率1.5至3倍。因为焊条的变更,焊接情况也就不同,兹概括地说在下面:——一束状焊条之由来束状焊条,对我国来说尚是新东西,因此有简单地谈一下发展的必要。束状焊条之制造和使用,是在苏联石油工业厂房建筑工作中开始,它的发明人是科学工作者伏洛琴同志。试验成功后,很快地得到政府的支持和推广,在各工厂中普遍实行,受到很大欢迎。在石油工业部有二位电焊革新家拜其 Recently, many factories adopted the rapid welding method, and achieved some results, especially in the most common welding; because it does not require special equipment, nor as short arc or deep penetration welding method requires special welding rod to use, but only Increase teaching, make a few rods tight together into a bundle (beam electrode) to replace the work of a welding rod, improve productivity 1.5 to 3 times. The welding situation is different because of the change of the welding rod. It is summarized as follows: - The formation of a bundle of welding electrodes is still new to our country. Therefore, it is necessary to briefly discuss the development. The manufacture and use of the beam-shaped electrode started in the construction work of the Soviet petroleum industry plant. The inventor of the beam electrode was comrade Voloqin, a scientist. After the successful test, it was quickly supported and promoted by the government, which was widely practiced in various factories and was greatly welcomed. In the oil industry there are two electric welding innovators worship it