【摘 要】
：
Kinetic parameters of the electrode reactions were measured by investigating steady-state current-potential behaviors. The Tafel slopes of cathodic and anodic p
【机 构】
：
School of Metallurgical Science and Engineering
论文部分内容阅读
Kinetic parameters of the electrode reactions were measured by investigating steady-state current-potential behaviors. The Tafel slopes of cathodic and anodic processes are -0.113 8 V and -0.041 18 V, the anodic and cathodic apparent transfer coefficients are 0.519 3 and 1.435 2, respectively, and the stoichiometric number of rate-determining step is 1. The theoretical kinetics equation of electrode reaction was deduced, from which the dynamic parameters can be calculated as follows: the cathodic and anodic Tafel slopes are -0.118 V and -0.039 4 V, respectively, consisting with the experimental values. Finally, the correctness of the mechanism was further demonstrated using apparent transfer coefficient according to the electrochemical dynamic equation of multi-electron reaction.
其他文献
铱催化不对称氢化反应是形成碳碳、碳氮和碳氧键的重要合成方法.综述了近年来铱催化碳碳双键、碳氧双键、碳氮双键不对称氢化反应的最新研究进展.
为了研究复杂系统及复杂性科学问题,人们提出多Agent模型进行建模和分析.多Agent的群体行为是复杂系统研究所必须解决的问题,而其中的扩散趋同更是相关领域的研究热点.文中首
经等离子重熔的Ａ１－１６Ｓｉ合金与电阻炉重熔的相比，组织有明显的细化效果：初晶Ｓｉ最大长度由１２０μｍ变为１０μｍ，共晶 Ｓｉ最大长度由 ７５ μｍ变为 ８ μｍ，并且这种细化效果随着放电电流和气流量的增大而增强，分析认
建立了中继镜系统模型,并进行了一定的近似,存某地区特定大气条件下,利用激光大气传输四维程序及相关程序模块,分别计算了固体激光中继镜系统和常规地基高能激光系统对1 km高
利用电磁热效应原理，探讨了超强度脉冲电流对高速钢裂纹止裂的可能性结果表明，利用电磁热效应可在裂纹尖端形成焊口，使裂纹尖端的曲率半径增大，抑制了裂纹扩展同时，对裂纹尖端热影
摘要介绍了获得满足△ｇ平行法则的位向关系、惯习面、正空间和倒空间准不变应变线的计算方法，解释了高锰钢中先共析魏氏组织渗碳体在奥氏体晶内析出时的Ｐｉｔｓｃｈ和Ｔ－Ｈ位向关系，计算得到的位
采用 ＳＥＭ， ＦＴ—Ｒａｍａｎ， ＸＲＤ和 ＥＤＸＡ对 ＣＶＤ金刚石膜自发剥落后的 ＹＧ８硬质合金基体表面的形貌、相结构和微区化学成分进行了表征，结果表明，该表面上存在石墨碳相、呈针片状；沉积金刚石膜后基体表面的ＷＣ颗粒显著
应用定向凝固技术制备了Ｃｒ系白口铸铁，采用萃取法制备碳化物试样，用失重法测得腐蚀速率，并通过电化学法探讨Ｃｒ系白口铸铁在腐蚀介质中的相间腐蚀机理，结果表明：（１）Ｃｒ系白口铸铁在腐蚀介质中
A new method was proposed for constructing total variation diminishing (TVD) upwind schemes in conservation forms. Two limiters were used to prevent non-physica
The photochromic diarylethene, 1,2-bis(1,4-dimethyl-2-phenyl)perfluorocyclopentene has been synthesized and its single crystal can be obtained in hexane at -4℃