【摘 要】
：
A high-precision digital measuring scheme for half-wave voltage of Y-tap multiple integrated optical circuits is proposed. This scheme is based on Sagnac interferometer modulated with digital step waveform whose frequency is half of eigen frequency of the
【机 构】
：
TheInstituteofOptoelectronicsTechnology,BeijingUniversityofAeronauticsandAstronautics,Beijing100083
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
A high-precision digital measuring scheme for half-wave voltage of Y-tap multiple integrated optical circuits is proposed. This scheme is based on Sagnac interferometer modulated with digital step waveform whose frequency is half of eigen frequency of the interferometer. The technology and measuring precision are discussed. An experimental setup is made and the temperature-dependences of half-wave voltage of two samples are studied. Analysis and experimental study prove that this scheme is convenient and accurate.
其他文献
与可见光图像相比,红外图像的分辨率较低,景物边缘较为粗糙,传统的自动调焦技术无法直接用于红外热成像系统。为了解决这一问题,采用基于红外图像边缘特性的自动对焦算法,建立快速有效的对焦评价函数,驱动高精度光机闭环控制单元,以实现快速、准确的红外自动对焦。系统包含数字处理单元和运动控制单元。其中数字图像处理单元主要进行红外数字图像的采集,利用Roberts梯度算子提取红外图像中的信息量,并统计边缘点数以
Based on the weakly coupled-mode theory, the coupled-mode equations of the spatial multiwaveguide system are presented in general. The intensity distribution in each waveguide is determined by numerical method. Optical logic devices based on spatial multi
利用兰州大学大气科学学院半干旱气候变化教育部重点实验室(SACOL站)气溶胶地基观测资料订正出的地表反射率及构建的沙尘气溶胶模型，借助6S大气辐射传输模式，对Terra卫星上的中分辨率成像光谱仪(MODIS)的L1B多光谱资料，进行了沙尘气溶胶光学厚度的个例反演试验。结果表明，四种反演方案的沙尘气溶胶光学厚度的区域分布均比较合理，说明反演方法可行；考虑了波长指数，并用SACOL资料构建的气溶胶模型进行大气订正得出的地表反射率反演出的沙尘气溶胶光学厚度最接近实际测量值，误差为-7.3%。通过对反演过程中的误
GaN光电阴极的制备成功与否需用科学手段加以评估。在GaAs光电阴极多信息量测试系统的基础上, 增设紫外光源, 并对评估软件重新加以编写, 设计出GaN光电阴极测试评估系统。利用该系统测试了GaN光电阴极在制备过程中的Cs源电流、O源电流、光电流和激活室真空度等多个信息量, 并利用激活后的光谱响应对阴极进行了评估, 实现了对GaN光电阴极性能的客观评价。
以太阳能多孔吸热器等热利用系统为研究背景, 针对多孔层表面的红外测温问题, 基于反向蒙特卡罗法建立了三维非等温各向异性散射多孔层的红外测温模型, 讨论了散射类型、多孔层厚度、基材发射率、孔隙率、孔径等物理性质和结构参数对红外测温误差的影响, 提出了一种多孔层表面温度的反向计算方法。结果表明, 将红外温度的实验测量值视作多孔表面温度会导致一定误差; 后向散射可削弱高温背景辐射, 从而减小探测温度较高时的误差, 但增大了探测温度较低时的误差; 高孔隙率(大于0.93)会造成测温误差迅速增大; 测温误差小于2%
Optical parameters (properties) of tissue-mimicking phantoms are determined through nonin-vasive optical imaging. Objective of this study is to decompose obtained diffuse reflectance into these optical properties such as absorption and scattering coeffici
A novel dual-loop optoelectronic oscillator (OEO), which is constructed based on all optical signal processing, is proposed and analyzed. By inserting an erbium-doped fiber amplifier (EDFA) and a fiber Bragg grating (FBG) on the optical domain, the amplif
Multicore fibers are expected to be a game-changer in the coming decades thanks to their intrinsic properties, allowing a larger transmission bandwidth and a lower footprint in optical communications. In addition, multicore fibers have recently been explo
The squeezed state is important in quantum metrology and quantum information. The most effective generation tool known is the optical parametric oscillator (OPO). Currently, only the squeezed states of lower-order spatial modes can be generated by an OPO.
基于互易定理研究了光波入射时微粗糙面与其上方球形粒子复合模型的光散射。根据粗糙表面电流积分方程并利用表面微扰展开,得到了微粗糙面表面极化电流的迭代解,给出了耦合电场的计算方法。结合散射耦合场散射矩阵和已有的微粗糙面及球形粒子的散射矩阵,给出了复合模型散射截面的计算公式,数值计算了复合模型的后向散射截面并进行了详细讨论。