我厂磨工赵光平同志,在加工如图1所示的工件时,改进了一套夹具如图2。夹具体上有8个孔,每个孔可以装入8个工件。工件不磨光的端面跟夹具体的端面平行,并且在一直线上,这样才能保证磨削以后,工件的尺寸一致。工件装好后,用黄铜螺钉紧固,然后把夹具装在电磁工作台上吸牢,即可进行磨削。使用这套夹具加工, Our mill worker Zhao Guangping comrades, in the processing of the workpiece as shown in Figure 1, improved a fixture as shown in Figure 2. There are 8 holes on the clamp, each hole can hold 8 workpieces. The polished surface of the workpiece is parallel to the end surface of the clamp, and in a straight line, so as to ensure the same size of the workpiece after grinding. After the workpiece is installed, fasten it with brass screw, and then fix the fixture on the electromagnetic workbench and hold it for grinding. Use this fixture processing,