通常研磨锥度环规均采用传统的整体圆锥研磨杆进行配研。用这种方法研磨出的雏孔光洁度和精度都不高,且研磨杆磨损块。改用圆柱研磨杆研磨(如图所示),环规紧固在内圆磨床的头架卡盘内,头架偏转一相应的角度(等于锥孔斜角)。圆柱形研磨杆装于 Usually grinding taper rings are used with the traditional overall conical grinding rod with research. In this way, the accuracy and accuracy of the hole are not high, and the grinding rod wear block. Instead, grind it with a cylindrical grinding rod (as shown). The ring gauge is fastened in the headstock chuck of the internal grinder, and the headstock is deflected by a corresponding angle (equal to the bevel angle). Cylindrical grinding rod mounted on