Effect of sintering temperature and composition on microstructure and properties of PMS-PZT ceramics

来源 :中国有色金属学会会刊(英文版) | 被引量 : 0次 | 上传用户:yx10110605
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The piezoelectric ceramics xPb(Mn1/3Sb2/3)O3-(1-x)Pb(Zr1/2Ti1/2)O3 (abbreviated as PMS-PZT) were synthesized by traditional ceramics process. The effect of sintering temperature and the amount of Pb(Mn1/3Sb2/3)O3 (abbreviated as PMS) on phase structure,microstructure,piezoelectric and dielectric properties of PMS-PZT ceramics was investigated. The results show that the pure perovskite phase is in all ceramics specimens,the phase structure of PMS-PZT ceramics changes from tetragonal phase to single rhombohedral phase with the increasing amount of PMS. The dielectric constant -r,Curie temperature TC,electromechanical coupling factor kp and piezoelectric constant d33 decrease,whereas the mechanical quality factor Qm and dielectric loss tanδ increase with the increasing amount of PMS in system. The optimum sintering temperature is 1 200-1 250 ℃. It is concluded that the PMS-PZT (x=0.07) ceramics sintered at 1 250 ℃ is suitable for high-power piezoelectric transformer. These properties include -r=674.8,tanδ=0.005 25,kp=0.658,Qm1520,d33=230 pC/N,Tc=275 ℃.
其他文献
A new method of studying the corrosion inhibition mechanism of rare earth metal(REM) on LC4 Al alloy with the spilt cell technique was studied. The principle an
During cold ring rolling process,changing the sizes of forming rolls including driver roll and idle roll will lead to a change of amount of feed △h and contact
The oxidation behaviors of Nb67-xW15Si18Hfx (x=0, 5, 10) alloys were studied at 1 250 ℃ in air. It is found that the Nb67W15Si18 alloy has the best oxidation r
The deformation-induced nano-crystallization behavior of amorphous pure Ni was investigated by using a molecular dynamics simulation. The microevolution mechani
The ZnO and Zn1-xMnxO minicrystal were synthesized by chemical vapor transport (CVT). The electron trap structure (donor level) and process on the temporal beha
Compositionally graded Ba1-xSrxTiO3 (BST) (x = 0-0.3) thin films were prepared on Pt/Ti/SiO2/Si substrate at different substrate temperatures ranging from 550
CsLiB6O10(CLBO) is a new-type nonlinear optical crystal material. CLBO has many good performances,especially the frequency multiplication performance in deep ul
Polycarbonate (pc)/polypropylene (pp)/silicate attapulgite (AT) ternary nanocomposites were first prepared via the two-step melt blending process. Phase structu
CO2 laser beam welding of aluminum alloys with different thicknesses was carried out. The influences of laser power and travel speed on the weld width were anal
An electroless Ni-P plating treatment was applied on AZ91D magnesium alloy to improve its corrosion resistance. Optimum pretreatment conditions and optimum bath