论文部分内容阅读
(4)连接软盘驱动器的信号线。找出一条32线的扁平信号,连接适配卡的Floppy插座和软盘驱动器。注意,软盘信号线上一般应有五个插头,其中有三个大的插头和两个小的插头。大插头用于连接适配卡和5.25in的软驱,小插头用于连接3.5in的软驱。其中有一个大插头与其他4个插头的距离较远,此插头用于插在适配卡上相应的插座上。另外要注意,信号线是有方向的,一旦接反了,软盘即无法启动,但不会造成损失。连接时,信号线上为红色的端为第①脚,应接在适配卡或软驱上标记为1、2的一
(4) Connect the floppy drive signal cable. Find out a 32-line flat signal, connect the adapter’s Floppy socket and floppy drive. Note that the floppy disk signal line should generally have five plugs, of which there are three large plugs and two small plugs. Large plug for connecting adapter and 5.25in floppy drive, small plug for connecting 3.5in floppy drive. One of the large plugs has a long distance from the other four plugs, which are used to plug in the corresponding sockets on the adapter card. Also note that the signal line is directional, once reversed, the floppy disk can not start, but will not cause damage. When connected, the signal line on the red end of the first pin, should be connected to the adapter card or floppy drive labeled as a 1,2