自1975年以来,我厂熔模铸造车间采用固定式坩埚模型捣筑GGW-0.15型中频感应炉坩埚,即按坩埚尺寸,用壁厚1毫米的钢板焊接成坩埚模型。在每次捣筑新炉时,先逐层捣紧坩埚底部,然后把模型放入感应器中心,并加压固定,再填料逐层捣筑坩埚壁,直到感应器的上边缘,最后制出炉领和炉嘴。坩埚捣筑完毕后,不需取出模型,直接加炉料烘烤烧结坩埚。 Since 1975, I plant casting workshop using a fixed crucible model pounding GGW-0.15 medium frequency induction furnace crucible, that is crucible size, with a wall thickness of 1 mm welded into a crucible plate model. In each new pounding furnace, the bottom of the crumpling layer by layer tamping, and then put the model into the center of the sensor, and the pressure fixed, and then layering the crucible piled wall crucible until the upper edge of the inductor, the last furnace Collar and furnace mouth. After the crucible pounding, no need to remove the model, directly add baked baking sintering crucible.