【摘 要】
：
Springback is caused by the redistribution of stress in sheet material after the tooling is removed. Precise prediction of sheet springback is very important in
【机 构】
：
National Mold & Die CAD Engineering Research Center, Shanghai Jiao Tong University, Shanghai 200030,
论文部分内容阅读
Springback is caused by the redistribution of stress in sheet material after the tooling is removed. Precise prediction of sheet springback is very important in die design. Based on Hills yielding criterion and plane strain condition, an analytical model is proposed in this paper which takes into account the effects of contact pressure, the length of bending ann between the punch and die, transverse stress, neutral surface shifting and sheet thickness thinning on the sheet springback of V-bending. The predicted results by this analytical model indicated that the contact pressure and transverse stress have much effect on the springback when the bending ratio (the ratio of punch radius to sheet thickness) is less than five. The contact pressure declined when the length of bending arm goes up, which means that shorter length of bending arm will result in larger springback. The effect of neutral surface shifting on the springback is less than that of contact pressure and decreases with the bending ratio. However, this research showed that the influence of thickness thinning on the springback can be ignored. Comparison with finite element method (FEM) simulating results shows that the predicted results by the analytical model accord well with simulation results by FEM. In addition to that, the bending ability-the limit bending ratio for a given sheet thickness and material properties was also determined.
其他文献
Structural and magnetic properties of Fe-25Cr-12Co-1Si alloy thermo-magnetically treated under different external magnetic field conditions were investigated. O
随着中国经济的迅速发展,室内设计这个名词传入中国,中国建筑装饰行业逐步兴起,中国室内设计也迎来了新的春天,无论是设计的理念还是设计的手段都在和国际室内设计观念靠拢.
This paper discussed two methods to enhance the electrical conductivity of the carbon fiber(CF) electrically conductive concrete. The increase in the content of
Nanostructured yttria partially stabilized zirconia coatings were deposited by air plasma spraying with reconstituted nanosized powder. The microstructures and
本文来自于对活跃在SourceForge和GitHub上的项目的分析研究，同时我也在Twitter上向大家进行了调查，以免漏掉了很热门但是我却不知道的项目。
The mechanism responsible for the formation of recrystallization texture in cold-rolled Ti bearing interstitial free (IF) steel sheets was investigated using el
This Paper proposes a modified operation mode of batch extractive distillation with two reboilers.The separation of ethanol and water using as ethylene glycol i
To investigate the early-age behaviors of concrete under a restrained condition, a set of apparatus was developed. In this way, the tensile creep and other earl
在盐法破壁的基础上,添加质壁分离剂。当酵母浓度为10%、氯化钠浓度为5%时,添加5 mL乙酸乙酯,并在100℃下抽提2 h,可以增加核酸的提取率和纯度,使得提取率达到60%。
The electrical conductivity of Cu-10Ag in situ filamentary composite was studied during the deformation and annealing processes. The dependence of electrical re