【摘 要】
：
By adjusting pH values of reactant system, the mass ratio of stabilizer/water and aging temperature, size controllable spherical silver nanoparticles (NPs) were synthesized. The properties of silver NPs are characterized by X-ray diffraction (XRD), transm
【机 构】
：
DepartmentofPhysics,OceanUniversityofChina,Qingdao266100,ChinaQingdaoInstituteofBioenergy
【出 处】
：
OptoelectronicsLetters
论文部分内容阅读
By adjusting pH values of reactant system, the mass ratio of stabilizer/water and aging temperature, size controllable spherical silver nanoparticles (NPs) were synthesized. The properties of silver NPs are characterized by X-ray diffraction (XRD), transmission electron microscope (TEM) and ultraviolet visible (UV-VIS) absorption spectra. Within the pH values of 7.0-11.0, the aging temperature of 80 °C is better to improve silver NPs in shape to nearly sphere, concentrate size distribution and reduce aggregation than the aging temperature of 25 °C. The shape and dispersibility of silver NPs are the best when the pH of the reactant system is within 7.0-8.0. With pH of 7.5, aging at 80 °C, and stabilizer/ water mass ratio of 1%, the spherical silver NPs with sizes of 50-70 nm were synthesized. The results are promising to be used to synthesize core/shell NPs when silver NPs are as core.
其他文献
提出了一种基于级联马赫-曾德尔调制器(MZMs)倍频系数可调的相位编码信号光产生方法。该方法的系统核心器件为级联MZMs,通过合理选择两个MZMs的直流偏置电压和调制指数等参数,可任意选取±k(k=1,2,…,5)阶边带中的一组边带。通过可编程光滤波器滤除5阶以上的高阶边带,再结合相位调制,可产生载波2、4、6、8和10倍频的相位编码信号。该方法是通过改变施加在级联MZMs上的射频驱动信号幅度实现倍频系数调节,方案简洁灵活。通过仿真实验验
An improved scattering optical model was developed under cylindrical coordinate to simulate the thermal effect of diffusing applicator in laser interstitial thermotherapy (LITT). The thermal damage was calculated by finite element method (FEM) using Penne
本文从理论方面提出了开角型青光眼的激光小梁打孔术所涉及到的物理参量和激光的特性，详细地评述了房水的流体力学，打孔机理以及所要求的光学匹配系统。
本文介绍聚全氟乙丙烯包皮的氟锆酸盐(ZrF4-BaF2-LaF3-AlF3-NaF)玻璃光纤的制备方法.研究了各种工艺因素对氟锆酸盐玻璃和光纤散射损耗的影响.结果表明,选择适当的熔化温度和均化时间,玻璃熔化和光纤拉制时环境中低的水含量是制得的损耗氟锆酸盐玻璃光纤的关键;配合料中引入适量NH4HF2,选用温度结构合理的拉丝炉及拉丝工艺也有助于降低光纤的损耗.在此工作基础上,获得了波长2.32μm处损耗为0.24dB/m的氟锆酸盐玻璃光纤.
We discuss the optimal design of line-tapered multimode interference (MMI) devices using a genetic algorithm (GA). A 1×4 MMI device is designed as a numerical example. Compared with the conventional design based on self-imaging theory, the present method
为了在有限的太阳观测窗口内获得高质量的太阳光谱数据,需保证太阳进入观测窗口时仪器已完成自身预热。为保证仪器预热时间的一致性,需在轨实时预报预热开始时刻,需对每轨太阳开始进入仪器观测窗口的时间进行短时间高精度预报。详细介绍了一种由卫星平台当前广播时间和轨道瞬根推导预报时刻太阳角度的方法。利用该方法预报某一太阳同步轨道卫星本体坐标系下的太阳角度,并将预报结果与STK仿真结果进行比对。该预报方法在预热时间内的最大角度误差为0.5°,导致预热时间最大偏差为20 s,满足1 min的指标要求。分析了预报方法中的主要
本文用卢瑟福背散射和光吸收技术研究了高剂量Ag离子注入SiO_2玻璃以及退火后的状况.吸收光谱测量表明,注入的Ag离子聚集形成了胶态粒子,其等离子共振峰的极大值在400nm处.运用米(Mie)理论和德拜(Doyle)方法,根据测得的等离子共振峰的光宽度,估算出Ag胶态粒子的半径约为18(?).