Theoretical and experimental study of initial cracking mechanism of an expansive soil due to moistur

来源 :中南大学学报(英文版) | 被引量 : 0次 | 上传用户:zcxwlh
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Swelling and shrinkage due to moisture-change is one of the characteristics of the expansive soil,which is similar to the behavior of most materials under thermal effect.If the deformation is restricted,stress in expansive soil is caused by the swell-shrinking.The stress is defined as “moisture-change stress” and is adopted to analyze swell-shrinkage deformation based on the elasticity mechanics theory.The state when the total stress becomes equal to the soil tensile strength is considered as the cracking criterion as moisture-change increases.Then,the initial cracking mechanism due to evaporation is revealed as follows:Different rates of moisture loss at different depths result in greater shrinkage deformation on the surface while there is smaller shrinkage deformation at the underlayer in expansive soil; cracks will grow when the nonuniform shrinkage deformation increases to a certain degree.A theoretical model is established,which may be used to calculate the stress caused by moisture-change.The depth of initial cracks growing is predicted by the proposed model in expansive soil.A series of laboratory tests are carried out by exposing expansive soil samples with different moisture-changes.The process of crack propagation is investigated by resistivity method.The test results show good consistency with the predicted results by the proposed theoretical model.
其他文献
Aging precipitation and solid solution heat treatment were carried out on three steels which have chromium content of 18%,manganese content of 12%,15%,18%,and nitro
Systolic implementation of multiplication over GF(2m) is usually very efficient in area-time complexity,but its latency is usually very large.Thus,two low laten
Abstract:Spinel compounds LiNi0.5Mn1.3Ti0.2O4 (LNMTO) and Li4Ti5O12 (LTO) were synthesized by different methods.The particle sizes of LNMTO and LTO are 0.5-2 an
Auger electron spectroscopy (AES) was used to investigate the grain boundary segregation of arsenic and nitrogen in a kind of microalloyed steel produced by a c
In order to meet the severe requirements of market and reduce production costs of high quality steels,advanced run-out table cooling based on ultra fast cooling
A novel photocatalyst,bismuth oxychloride (BiOCI) micro-nano particles with a fine ferrite plate structure,was prepared by a low-cost,simple hydrolytic method.T
The 8% (mass fraction) yttrium-partially-stabilized zirconia (8YSZ) ceramic was fabricated via liquid phase sintering at 1 200-1 400 ℃ by adding different mass
In order to effectively analyse the multivariate time series data of complex process,a generic reconstruction technology based on reduction theory of rough sets
Numerical simulation and experimental study of the Vickers indentation testing of the Al2O3 ceramic coated by diamond-like carbon (DLC) layer were conducted.The
Based on the compression mechanism for analyzing the cavity expansion problem in soil under high stresses,generalized non-linear failure criterion and large str