C61125车床溜板部件较重,快速移动较频繁。溜板的十二个部位全靠一手摇泵来润滑,因吸油高度较高,(约450毫米,)泵流量小,又无法观察油泵的工作情况,经常使各部位润滑不良,以致造成床面拉伤。现将手动润滑改为自动润滑:在溜板箱内快速移动电机上方,安装一柱塞泵(图1)。把油排到分油器,分油器有一油口通到油窗中去。每班前可将快移离合器拨在空位上,使快移电机空转半分钟,即可以使各部润滑充足。在机床工作进给时,快移电机总是被带转动,油泵少量排油,供各部润滑。当溜板快速运动 C61125 lathe slide components heavier, fast moving more frequently. The twelve parts of the slide board are all lubricated by a hand pump. Due to the high suction height (about 450 mm), the pump flow is small and the operation of the pump can not be observed. The parts often lubricate badly so that the surface of the bed strain. The manual lubrication is now changed to automatic lubrication: In the slide box above the motor quickly move, install a plunger pump (Figure 1). Discharge the oil to the oil separator, the oil separator has an oil port to the oil window. Before each shift can be fast clutch clutch in the vacancy, so that fast-moving motor idling for half a minute, you can make the Department adequate lubrication. In the work of the machine feed, fast moving motor is always with the rotation, a small amount of oil pump oil for lubrication of ministries. When the slide fast movement