Morphology and distribution of Al3Fe phase in hypereutectic Al-Fe alloy solidified under magnetic fi

来源 :中国铸造:英文版 | 被引量 : 0次 | 上传用户:shigang_fly1
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
在这研究,(低) DC 和交流磁场和高磁场在 Al3Fe 的形态学和分发上的这些磁场的影响在 Al-2.89Fe 合金分阶段执行的 Al-2.89Fe alloy.The 的团结过程期间独立被使用是 investigated.The 微观结构,样品的宏观结构用结果显示出的光 microscope.The 被观察在高级低共熔体的 Al-2.89Fe 合金的主要 Al3Fe 阶段粒子的多数在底部被聚集并且 Al3Fe 阶段的长轴垂直地排列到磁场 direction.Also,磁场的效果的机制被讨论。
其他文献
In the present study, the microstructure and mechanical properties of cast Fe-10Cr-1.5B(FCB) alloy after different heat treatments were studied. The results sho
期刊
To improve the crack-resistance of the mould for silica sol bonded quartz based ceramic mould casting,aluminum silicate fibers with the diameter ranging from 5
The relative performance of coatings for furan resin sand moulds [P-toluol sulphonic acid(PTSA) as hardener] [FRS-PTSA moulds], was compared by analyzing the su
期刊
The effects of Nd addition on corrosion behavior of Mg66Zn30Ca4 amorphous alloys in simulated body f luids(SBF) were studied in this paper. Electrochemical prop
期刊
Founded in 2012,the National Joint Engineering Research Center of High Performance Metal Wear Resistant Materials Technology at Jinan University,one of the'
The aim of the present research is to provide a technique for preparing open-cell Al2O3-ZrO2 ceramic foams with uniform cell size.This technique used plant seed
期刊
热压力模拟能提供一本科学参考书消除象快克,剩余压力集中化和变丑等等那样的缺点,在扔团结期间由热应力引起了。为了在扔期间学习热压力分发,处理,一个单方的热压力的联合模特儿
The hole defects can easily occur in magnesium alloy castings that are prepared by low pressure lost foam casting(LP-LFC)process when the process parameters suc
Numerical modeling of the tilt casting process for TiAl alloys was investigated to achieve a tranquil mould filling and TiAl castings free of defects. Titanium
期刊
The influence of Sr addition on pore formation in directionally solidified Al-12.3wt.% alloy was investigated using X-ray detection, optical microscope, and SEM
期刊