An analytic model based on ANSYS/LS-DYNA has been developed on the cold rolling process for Q235 steel rebar with 12 mm in diameter. The elastic-plastic finite element method (FEM) and the cold deformation resistance model of Q235 steel were adopted in this model. Deformation uniformity of the final product has been analyzed using this model. The results indicate that the uniformity of the final product is obtained only as the centerline of the bending rolls is vertical to the centerline of the driven roll and parallel to the centerline of the drive roll in the whole rolling process. Besides, the number of the bending rolls must even realize the continuous bending and reverse bending process. Also, the number of the bending rolls must match the deformation degree of the workpiece in the cold rolling process. The validity of this finite element model was verified by the size and distribution of grains from the billet to the rebar in a practical cold rolling process. An analytic model based on ANSYS / LS-DYNA has been developed on the cold rolling process for Q235 steel rebar with 12 mm in diameter. The elastic-plastic finite element method (FEM) and the cold deformation resistance model of Q235 steel were adopted in this model. Deformation uniformity of the final product has been analyzed using this model. The results said that the uniformity of the final product is obtained as the centerline of the bending rolls is vertical to the centerline of the driven roll and parallel to the centerline the number of the bending rolls must even realize the continuous bending and reverse bending process. Also, the number of the bending rolls must match the deformation degree of the workpiece in the cold rolling process The validity of this finite element model was verified by the size and distribution of grains from the billet to the rebar in a practical cold rolling process.