Symmetrical short-period and high signal-to-noise ratio heterodyne grating interferometer

来源 :ChineseOpticsLetters | 被引量 : 0次 | 上传用户:chenquanchenwen
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
A symmetrical heterodyne grating interferometer with both a short period and high signal-to-noise ratio is proposed. It possesses good immunity to environmental disturbances and can simultaneously achieve high resolution and stability. The experimental results show that the standard deviation of 24.67 nm can be realized for the long range of 10 mm. The measurement resolution of better than 2 nm is achieved with the theoretical resolution of 12 pm. Additionally, system stability at less than ±1.5 nm is obtained in just over 10 min. The measurement errors, including cosine error, nonlinear error and non-common path error, are discussed as well.
其他文献
针对光刻用准分子激光器的激励技术,利用拉普拉斯变换方程对脉冲变压器高压充电过程进行了分析,验证了桐合系数于与压缩高压无电时间的重要作用。捐合系数越接近于1 ,高压无电时间越短。介绍了充电电路与磁开关结合后完成快放电的过程,并提出了一种控制谐振充电的方法。实现了对高压电容50μs 内的快充电。
Lens-less Fourier-transform holography has been actively studied because of its simple optical structure and its single-shot recording. However, a low-contrast interferogram between the reference and object waves limits its signal to noise ratio. Here, mu
本文就碰撞锁模染料激光器腔内各元件对脉冲的影响进行了定量分析,对脉冲的形成进行了计算机模拟,得到了脉冲波形的非对称数值解,并且根据模拟结果对脉冲的形成机理进行了讨论.
期刊
This paper proposes the design and characterization of microstructure optical fiber for gas sensing applications. The aim is to detect toxic and colorless gases over a wide transmission band covering 0.80 μm to 2.00 μm wavelength. Numerical investigation

报道了一种采用新型二维材料二硒化铪可饱和吸收体的被动调Q掺铒光纤激光器。通过机械剥离法制备了二硒化铪薄片,将其作为可饱和吸收器件插入掺铒光纤激光器谐振腔内,实现了稳定的调Q脉冲激光输出。在泵浦功率为140 mW时,通过控制偏振控制器调节谐振腔内的偏振状态,获得了中心波长为1532.3 nm,3 dB谱线宽度为0.68 nm的稳定调Q脉冲输出;当泵浦功率增加到360 mW时,脉冲输出的重复频率从42.3 kHz变化到88.2 kHz,脉冲宽度从3.3 μs变化到1.8 μs。实验结果表明,在最大泵浦功

The influence of technique parameters on the temperature coefficient of resistance (TCR) of reduced graphene oxide (RGO) films is studied. These technique parameters include the ultrasonic time, solution concentration, and heat treatment temperature. Resu
固着磨料工艺主要针对某空间相机的高精度平面折反镜而开发,分别从微观结构的仿真计算和人工神经网络两个角度对此工艺加工碳化硅反射镜表面粗糙度进行分析。一方面引入了二维粗糙度的在微观结构仿真概念,在人工神网络方面使用双隐层神经网络对固着磨料工艺的加工结果进行了分析,使得网络的性能大幅提高,收敛结果达到了8.4075×10-5,并对网络性能进行了验证,标准化后的预测集与实验验证集距离偏差为0.2113。完全满足固着磨料工艺对表面粗糙度的预测需求。
期刊
同位素分离在技术上纯属最困难的工艺课题。铀同位素具有特别的经济价值。目前,它在世界各地的轻水原子反应堆中作为发电的核燃料,天然铀中,235U的浓度约为0.7%,用于轻水原子反应堆时,它的浓度必须提高到左右。
期刊