【摘 要】
：
A new method was introduced to fabricate porous coating and control its porosity by changing spray parameters. Two models were constructed to simulate the defor
【机 构】
：
School of Mechanical Science & Engineering
论文部分内容阅读
A new method was introduced to fabricate porous coating and control its porosity by changing spray parameters. Two models were constructed to simulate the deformation of droplet and the deposition process of splats on substrate. Considering the gap-pore, step-pore and shield-pore in the presented models, the influence of spray angle on the porosity of coating was mainly investigated. The simulation and experimental results show that the presented method is suitable for fabricating controllable-porosity coating. The porosity of coating can reach 49%. When the spray angle is lower than 30°, the porosity of coating rapidly increases because of shielding effect. Moreover, powder size and impact velocity also influence the porosity. Besides, a new forming method of graded porous coating was simulated by continuously changing the spray angle.
其他文献
强耦合常数αs(s)是量子色动力学最重要的参数.基于BES的R值测量结果,分别利用精确到3圈和4圈的微扰QCD的计算,测定了αs(s)在2.0-3.7 GeV能量范围的数值,并推断了αs(s)演化
用微扰QCD对B(s)→Φρ衰变进行了研究,考虑了因子化和非因子化图的贡献,得出了B(s)→Φρ衰变的分支比以及纵向极化衰变、横向极化衰变之比,所得到的结果与现在的实验数据吻
A model-independent 3 - D texture synthesis ofphysical and stochastic algorithms, based on an amplitudemodulation method, is presented to realize 3 - D fabricdy
Absolute nodal coordinate formulation for a rectangular plate with large deformation was improved.Based on nonlinear elastic theory, a precise strain expression
介绍了基于AT的FMA方法在BEPCⅡ上首次较系统的应用.将AT分析结果与MAD和SAD程序比较,吻合较好.考虑高频腔和辐射阻尼效应,利用FMA分别对BEPCⅡ对撞模式和注入模式进行分析,
The paper proposed a terminal sliding mode control method for the delayed input system with uncertainties. Firstly, through the state transformation, the origin
In this paper, a detailed introduction is given to the check method of the BRDF experiment bench which is built on our own. Measurement is made on the BRDF of t
The unsteady flow of viscoelastic fluid in a cylindrical pipe was investigated using the fractional Maxwell model. Two special cases of unsteady pipe flow were
Based on the theory of one-dimensional separate soliton pairs formed in a serial photorefractive crystal circuit, we investigated the temperature effects of the
5 critical quality characteristics must be controlled in the surface mount and wire-bond process in semiconductor packaging. And these characteristics are corre