【摘 要】
：
The physical performance of recycled asphalt was used as the main evaluation index to study the optimal range of a self-made rejuvenator. Through the penetration, viscosity and gel permeation chromatography (GPC) tests, the diffusion degree of the rejuven
【机 构】
：
School of Architecture and Civil Engineering,Xi’an University of Science and Technology,Xi’an 710054
【出 处】
：
武汉理工大学学报（材料科学版）（英文版）
论文部分内容阅读
The physical performance of recycled asphalt was used as the main evaluation index to study the optimal range of a self-made rejuvenator. Through the penetration, viscosity and gel permeation chromatography (GPC) tests, the diffusion degree of the rejuvenator under different temperatures and time process was analyzed, and the diffusion efficiency of the rejuvenator was evaluated from the macro and micro perspective. The regeneration mechanism of the rejuvenator in the aged asphalt was also analyzed using the Fourier transform infrared spectroscopy (FTIR), scanning electron microscope (SEM) and chemical composition tests. The research results showed that the optimum rejuvenator content was about 3％. Higher temperature and longer time were beneficial to improving the permeability and diffusion of the rejuvenator. During the aging process, the light components were reduced, and more macromolecular asphaltenes were generated as well as a large number of carbonyl and sulfoxide. After diffusion and regeneration, the light components in the asphalt were supplemented, the wrinkles and gullies of the aged asphalt were almost improved to the surface state of the matrix asphalt.
其他文献
提出了一种数字恒定导通时间(COT)控制的DC-DC Buck变换器.通过跨导放大器、流控振荡器(CCO)和数字滤波器对电感电流进行采样,形成电流内环.在基于ADC、PI补偿器的电压外环输出信号上叠加由误差电流、CCO产生的斜坡补偿信号,最终形成双环控制的Buck变换器电路.提出的数字谷值电流模COT控制方法采用数字电流内环和额外的斜坡补偿方式,加快了电路的瞬态响应,同时保持了数字电源高输出精度的特性.该Buck变换器在输入电压5V、输出电压3.3V、开关频率1 MHz下进行了仿真验证.仿真结果表明,负载
集成电路规模的急剧增大显著加了测试成本.针对集成电路测试成本过高的问题,提出了一种适应性测试方法.将最小冗余最大相关算法与BP神经网络相结合.首先通过最小冗余最大相关算法选择重要的测试项,仅测试重要的测试项并组成特征集合,然后使用BP神经网络模型预测测试结果.实验结果表明,相较于传统测试方法,该方法以牺牲0.1％的测试逃逸率为代价,降低了45％以上的测试成本.与其他适应性测试方法相比,该方法的测试逃逸降低91％以上,可以在测试成本和测试质量之间选择最优解.
In order to enlarge the size of bulk metallic glasses (BMGs), two Cu36Zr48Al8Ag8 BMGs plates were successfully welded by friction stir welding (FSW) without obvious crystallization. The effect of friction stir welding on microstructure and mechanical prop
分析了助听器芯片中∑-△ADC的降采样滤波器、上采样滤波器的原理及实现技术.优化滤波器结构和滤波器系数,降低了芯片面积.采用可编程配置的滤波器系数,实现通带平坦度与过渡带带宽、采样率之间的动态切换.采用SMIC 130 nm 1P8M CMOS工艺进行了MPW流片验证.结果 表明,该滤波器可支持16 kHz、32 kHz采样率,满足不同采样率助听器DSP的需求.级联后滤波器的通带纹波为0.001 dB,阻带衰减达80 dB,群延时之和最大值为3.877 ms,满足助听器信号转换电路的要求.
Ni nanoparticles were coated uniformly on the surface of WC powder via a facile electroless plating method (abbreviated as WCN-EP), and then consolidated for mechanical and corrosion resistance performance characterization, in comparison with hand mixed W
Effects of layer quantities and stacking sequences on L-shape composite manufacturing qualities in using OOA(out-of-autoclave) prepregs were studied. The mechanisms of air evacuated in 5 kinds of lay-ups were revealed by image analysis of cut surfaces and
Al2O3 particles reinforced hypereutectic Al-Si composites were prepared by in situ Fe2O3/Al reaction system. The thermodynamic analysis and microstructure evolution were investigated by differential scanning calorimetry, optical microscope, scanning elect
A new strategy to fabricate oxygen-promoted Cu,N co-doped carbon (OP-CuN@C) composites is reported. The strategy consists of only two simple steps: chemical polymerization and high temperature carbonization. Electrochemical measurements were conducted to
The heavyweight ultra-high performance concrete (HUHPC) was prepared with barite sand partially replaced by titanium-rich heavy slag sand (THS) at replacement proportion of 0％, 30％, 50％, 70％ and 100％ in this work. The results show that THS incorporation c
The pre-soaked shale employed as an internal curing agent and CaO employed as expansion agent were incorporated into concrete to investigate their effects on the mechanical properties and autogenous deformation of early-age concrete. We have conducted the