当用金刚石修整平面磨床的砂轮时,一般的修整器由于经常是用同一个部位接触,因此,金刚石磨损很快,必须随时进行调整。如用图所示的修整器,可以消除上述缺点。修整器的支座较一般的结构型式略大一些,同时具有一个棱锥形的基面。基面的制造方法很简单,经过车、铣后即可形成四个三角形的支承面。装有金刚石的圆柱销用螺钉固定在支座上,将金刚石修 When using diamond grinding wheel grinder, the general dresser is often the same part of the contact, therefore, diamond wear quickly, must be adjusted at any time. As shown with the dresser, you can eliminate the above shortcomings. The dresser supports are slightly larger than the typical structure and have a pyramidal base. The manufacturing method of the base surface is very simple, after the car, milling can form four triangular support surface. Cylindrical pins with diamonds are bolted to the abutment and the diamond is repaired