XC 系列仪表可动部分的动圈是靠张丝支承的。轴座与动圈之间若粘接不牢会脱节。为保证粘接位置的准确和粘接处的牢固,现介绍粘接的具体方法:首先从磁路系统中取出可动部分,在轴座的焊接端焊下引线,用棉花蘸丙酮清洗动圈与轴承的粘接面,去除旧粘接痕迹。另找一硬纸片剪成与动圈内孔相等的宽度,在纸片中间画 XC series instrument movable part of the moving coil is supported by the filaments. If the shaft between the seat and the dynamic adhesion is not strong will be out of touch. In order to ensure the accuracy of the bonding position and the firmness of the bonding part, a specific method for bonding is as follows: Firstly, the movable part is removed from the magnetic circuit system, the lead wire is soldered on the welding end of the shaft seat, the moving coil is cleaned with cotton dipped in acetone And bearing adhesive surface, remove the old adhesive marks. Another find a piece of paper cut into the same width with the dynamic hole, painted in the middle of the paper