【摘 要】
：
The catalytic activity of poly(styrene-acrylic acid) (PSAA) supported neodymium chloride (NdCl3) complex for the copolymerization of styrene and 4-Vinylpyridine
【机 构】
：
College of Chemistry
论文部分内容阅读
The catalytic activity of poly(styrene-acrylic acid) (PSAA) supported neodymium chloride (NdCl3) complex for the copolymerization of styrene and 4-Vinylpyridine was studied. The influence of various factors, such as Al/Nd molar ratio, reaction time, macromolecular carrier (PSAA), and ratio of styrene to 4-vinypyridine (g/g), on the copolymerization yield of styrene and 4-Vinylpyridine was investigated. The results showed that the copolymerization of polar monomers with olefins occurred efficiently and the catalytic activity of polymer-supported catalyst was higher than that of the similar small molecular catalysts. The activity of PSAA·Nd complex increased with increasing Al/Nd molar ratios and decreased with increasing polymerization time. The highest activity of PSAA·Nd was observed at 120 min, and the highest yield was found at the ratio of styrene to 4-vinylpyridine of 4:2. DSC analysis presented that the resulted polymer had only one glass transition temperature, and showed very good thermal stability.
其他文献
丫他镇位于黔西南布依族苗族自治州册亨县西南部,传统农业发展主要依赖于传统种植业、林业的发展,产业结构较单一,农业发展理念落后,农产品特色不明显,市场竞争力较弱,在甘蔗
对7个杂交水稻新品种(系)进行筛选比较试验,结果表明,中优177、YⅡ优8188产量明显高于对照品种,达极显著差异,可在华宁县海拔1 300 m以下区域内逐步推广种植;宜香10号和蓉18
In this paper we present a strategy for tuning the crystal morphology of pharmaceutical compounds by the appropriate choice of solvent via an optimization model
This study presents a robust design method for autonomous photovoltaic (PV)-wind hybrid power systems to obtain an optimum system configuration insensitive to d
A typical 321 stainless steel/aluminum composite coating (321/Al coating) was prepared by high velocity arc spraying technique (HVAS) with 321 stainless steel w
Catalytic combustion of dimethyl ether (DME) over hexaaluminate catalyst BaNi0.2Mn0.8Al11O19-δ has been investigated. The catalysts were prepared with the sol-
A large-scale, thin wall duplex stainless steel impeller with complex geometry was deformed severely and unpredictably during casting and heat treatment process
Preparation and oxidation of an Al2O3-dispersed chromizing coating were investigated by chromizing an aselectrodeposited Ni-Al2O3 nanocomposite film using a con
This work develops an optimization-based methodology for the design and scheduling of batch water recycle networks. This task requires the identification of net