钻孔测斜资料的一般整理方法是做出井轴水平投影图和垂直投影图。实践中,我们发现此法有些缺点。做井轴水平投影图时,确定一个点的位置,在使用原始数据上有些混乱,有的用上测点的数据,有的用下测点的数据。再者,由于丈量、标定等技术原因,做出的图件略有误差,不易检查。做井轴垂直投影图时,岩层走向不好确定,且不说火成岩,就是沉积岩的产状,区域与局部、矿区与钻孔处皆有差异,而至今钻孔中测量产状的工作又很少进行,故垂直投影图就很难做出。针对上述问题,经过反复实践 The general method of drilling inclinometer data is to make horizontal well axis projection and vertical projection. In practice, we found that this method has some shortcomings. To do a horizontal projection of shaft axis, determine the position of a point, the use of the original data on some confusion, and some with the measuring point data, and some with the next measuring point data. Furthermore, due to the measurement, calibration and other technical reasons, made a slight error of the map, not easy to check. Do vertical well shaft axis projection, the rock formation to determine the bad direction, not to mention igneous rock is the occurrence of sedimentary rocks, regional and local, mining and drilling are different, and so far measured in the production of drilling work is very Fewer, so vertical projection is difficult to make. In response to the above problems, after repeated practice