Design of a High Efficiency Boost DC-DC Converter

来源 :天津大学学报(英文版) | 被引量 : 0次 | 上传用户:hitsyl
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
An accurate circuit of PWM/PFM mode converting and a circuit of auto-adaptively adjusting dimension of power transistor are described. The duty cycle of the signal when the control mode converts can be gained accu-rately by using ratios of currents and capacitances, and an optimal dimension of power transistor is derived with different loads. The converter is designed by 0.35 μm standard CMOS technology. Simulation results indicate that the converter starts work at 0.8 V input voltage. Combined with synchronized rectification, the transfer efficiency is higher than 90% with full load range, and achieves 97.5% at rating output.
其他文献
Granular matter is a large assemblage of solid particles,which is fundamentally different from any other type of matters,such as solid and liquid.Most models pr
Secretome,the totality of secreted proteins,is viewed as a promising pool of candidate cancer biomarkers.Simple and reliable methods for identifying secreted pr
An optimum design model has been proposed for carbon/carbon ablative property based on genetic algorithm,in which the optimum parameters are the number of woven
In this paper, the wind load on an arc-shaped canopy roof was studied with numerical wind tunnel method(NWTM). Three-dimensional models were set up for the cano
In mod manufacturing patt, there are many uncertain factors in the mod manufacturing process, such as changes of product attribute, changes of manufacturing res
Many simple nonlinear main journal bearing models have been studied theoretically, but the connection to existing engineering system has not been equally invest
In the pedestrian headform impact test mandated by the European pedestrian safety requirements, the contact friction between the headform and the engine hood af
The densities of CO_2 inclusions in minerals are commonly used to determine the crystallizing conditions of the host minerals. However, conventional microthermo
This work is aim at studying the dependence of fission yields on incident neutron energy,so as to produce evaluated yield sets of the energy dependence.Experime
The problem of leak location is actually a time delay estimation (TDE) problem. Since most exist-ing TDE methods may encounter the problem of high computational