标准产品钢筋弯曲机,是用可逆转换开关来控制钢筋的弯曲度数。这种控制方法,往往不是过弯就是弯曲度数不够,操作起来很难如意掌握,而且容易发生事故。我们针对弯曲控制机构存在的这一弱点进行了多次研究改进,最后改制成为用一对滑动斜铁来控制弯曲度数的钢筋弯曲机。 The standard product rebar bender uses a reversible changeover switch to control the degree of bending of the rebar. This kind of control method is often not a matter of cornering, that is, the degree of curvature is not enough, the operation is difficult to grasp, and accidents are prone to occur. We have made several studies and improvements on this weak point of the bending control mechanism, and finally changed it into a steel bending machine that uses a pair of sliding inclined irons to control the degree of bending.