论文部分内容阅读
FOUNDRY
【出 处】
：
中国铸造：英文版
【发表日期】
：
2017年1期
其他文献
Evidence of refilled chamber gas pressure enhancing cooling rate during melt spinning of a Zr50Cu40A
The influence of the refilled gas pressure on the glass forming behaviour of one of the best ternary glass forming alloys Zr50Cu40AI10 was studied for the melt
Investigation of ductile iron casting process parameters using Taguchi approach and response surface
To find the optimized levels of various casting parameters in the ductile iron casting, various casting defects and the rejection rate were observed from a medi
期刊
The equilibrium partition ratio, k, has been measured for Mn, Mo, Si, Ni and Cu in a ductile iron with composition(wt.%): 3.45 C, 0.25 Mn, 0.25 Mo, 2.45 Si, 0.5
期刊
The effects of ultrasonic vibration(UV)treatment on microstructure of semi-solid aluminum alloys and the application of UV in rheocasting process are reviewed.G
期刊
Since 1952,Huazhong University of Science and Technology(HUST)was founded,or even further back,the German doctor Erich Paulun founded Tongji Medical University(
投资扔广泛地在与精确性，通用性和正直的关键好处生产 TiAl 部件作为最好的选择被认出了。为投资扔的陶器的模子的 collapsibility 由于 TiAl 在房间温度的内在的易碎物在 TiA
With the sixth large-scale railway speed-up,the quality of the axles is essential to the safety of the locomotive.According to the high-speed axle technical sta
Semisolid rheoforming(SSR)is a promising technology for the production of Mg wrought alloy in foundry settings.In order to realize SSR,it is necessary to charac
The intermetallic Ti-43Al-2Cr-2Nb（at.%） alloy was directionally solidified in an electromagnetic cold crucible with different withdrawal rates（V） ranging from 0.2 t
The compressive properties of aluminum foams by gas injection method are investigated under both quasi-static and dynamic compressive loads in this paper. The e
期刊