【摘 要】
：
Thermoelectric materials, Mg2Si1-xGex (x=0, 0.2, 0.4, 0.6, 0.8, 1), have been prepared by bulk mechanical alloying (BMA) and hot pressing (HP). The electrical c
【机 构】
：
School of Materials Science and Engineering,Center for Collaborative Research
【基金项目】
：
Grand-in-Aid from MEST, Japan with the contract
论文部分内容阅读
Thermoelectric materials, Mg2Si1-xGex (x=0, 0.2, 0.4, 0.6, 0.8, 1), have been prepared by bulk mechanical alloying (BMA) and hot pressing (HP). The electrical conductivity, Seebeck coefficient and thermal conductivity were measured from room temperature up to about 700 K. The electrical conductivity of all the samples increases with increasing temperature, while the Seebeck coefficient and thermal conductivity decrease with increasing temperature.Mg2Si and Mg2Si0.8Ge0.2 possess negative type of conductivity, while for other compounds it is positive. At the same time, the effect of hot processing condition on thermoelectric properties was also investigated. The maximum figure of merit of Mg2Si0.6Ge0.4 was obtained with the processing parameter of BMA at 600 cycles and hot pressing at 773 K and 1 GPa for 1 h.
其他文献
The feasibility of forming pollution-free and environmentally benign Ce-based rare earth conversion coatings (short for RECCs) on AZ91 magnesium alloy to enhanc
A new forming process, ceramic matrix composites thixoforming in pseudo-semi-solid state, was proposed based on powder metallurgy technology combined with the s
The vacuum-free vibration liquid phase(VLP) diffusion-bonding of SiCp/ZL101A composites was investigated. The effects of vibration on the interface structure, t
The effect of Cu on the microstructure and mechanical properties of 2519 aluminum alloy was investigated by means of tensile test, microhardness test, transmiss
YAG:Ce3+ phosphor particles were prepared using polyacrylamide gel method. The structure evolution of powders during annealing process was followed by X-ray dif
The hydrodynamic deep drawing process enables net shape or near net shape forming of complicated sheet metal parts made from difficultly forming materials, such
Although biometallic materials have been used as bone implant materials for a long time, they are still detected as foreign bodies by human immune system. Calci
The reverse microemulsion composition consisting of 37. 0% cyclohexane, 26.0% surfactant (TX-10and AEO9), 13.0% n-pentanol and 24.0% aqueous phase was investiga
External cooling technology is one of the key technologies to realize fast-casting-rolling process of aluminum, i.e. using compulsive cooling on the external su
The films of octadecene, dodecene, and undecenoic acid were prepared on H-terminated Si surface in the presence of ultraviolet irradiation. The resulted films w