论文部分内容阅读
我站3000m3储油罐于2004年7月大修,大罐浮子液位计制作安装在透光孔上,运行到2010年存在着四个重大问题,包括检测液位不准、浮漂经常被卡住、钢丝绳起倒刺与油封装置加油时经常溢出或不足。我站生产技术QC小组针对上述四个问题,开展了一系列技术改造活动。本文主要是对我站生产技术QC小组对此次技术活动的过程结果做了一些说明,包括设计构想、更换钢丝绳、分析确定最佳方案、就制定的对策的事宜的相关介绍,但在文章开头,笔者首先对浮子液位计的概念做了简要的概述。
My station 3000m3 oil tank overhaul in July 2004, the production of large tank float level gauge installed in the light through the hole to run until 2010 there are four major issues, including the detection of liquid level is not allowed to float often stuck , Wire rope barb and seal often refueling or fuel overflow. I station production technology QC team for the above four issues, launched a series of technological transformation activities. This article mainly gives some explanations about the process result of this technical activity from the QC team of our station production technology, including the design concept, the replacement of wire rope, the analysis of the best plan and the introduction of the countermeasures for the formulation of the measures, but at the beginning of the article , I first made a brief overview of the concept of the float level gauge.