2. 您的位置
3. 首页
4. 期刊论文
5. Low-cost solid FeS lubricant as a possible alternative to MoS2 for producing Fe-based friction mater

Low-cost solid FeS lubricant as a possible alternative to MoS2 for producing Fe-based friction mater

来源 :矿物冶金与材料学报：英文版 | 被引量 : 0次 | 上传用户：chaoge100

【摘 要】

：

瞬间 ₂-Fe, FeS-Fe 的三个反应系统，和 FeS-Fe-Mo 被设计为生产基于 Fe 的磨擦材料作为瞬间 ₂ 的一种选择调查 FeS 的使用。样品被粉末冶金学，和他们的

【作 者】

：

Tao Peng Qing-zhi Yan Yan Zhan 

【机 构】

：

LaboratoryofSpecialCeramicsandPowderMetallurgy

【出 处】

：

矿物冶金与材料学报：英文版

【发表日期】

：

2017年1期

【关键词】

：

磨擦材料 稳固的润滑剂 铁硫化物 铝硫化物 friction materials  solid lubricants  iron sulfides  molyb 

【基金项目】

：

Financial supports from the National Natural Science Foundation of China （No. 51572026）, the State Key Laboratory of Traction Power, Southwest Jiaotong University, China （No. TPL1612）

下载到本地 , 更方便阅读

下载此文 赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

瞬间 ₂-Fe, FeS-Fe 的三个反应系统，和 FeS-Fe-Mo 被设计为生产基于 Fe 的磨擦材料作为瞬间 ₂ 的一种选择调查 FeS 的使用。样品被粉末冶金学，和他们的阶段准备作文，微观结构，机械性质，和磨擦性能被描绘。结果证明瞬间 ₂ 与矩阵反应当时，生产铁硫化物和瞬间在 1050 点的 sintered ? 扯慴湩摥戠 ? 湡攠敬瑣潲档浥捩污洠瑥潨吗？

其他文献

Effects of ausforming strain on bainite transformation in nanostructured bainite steel

The effects of ausforming strain on bainite transformation in high-carbon low-alloy nanobainite steel were investigated using a Gleeble 3500 thermomechanical si

期刊

phaseTRANSFORMATIONSKINETICSBAINITESTEELSNANOSTRUCTUREDmaterialsAUSFORMI

天津设施种植业现状、问题与发展建议

设施种植业是通过采用现代农业工程技术，为植物生长提供适宜温度、湿度、光照等条件，而在一定程度上摆脱自然环境对农业生产的束缚，它具有高投入、高产量、高效益等特点，是现代农

期刊

设施种植业现状问题建议天津protected industry current situation problem countermeasure

Effects of the precipitation of stabilizers on the mechanism of grain fracturing in a zirconia meter

The mechanism of grain fracturing in a zirconia metering nozzle used in the continuous casting process was studied. The phase composition, microstructure, and c

期刊

破裂机理氧化锆稳定剂喷嘴晶粒计量沉淀X射线荧光分析仪continuous casting metering nozzle partially s

Dynamic characteristics of the planetary gear train excited by time-varying meshing stiffness in the

Wind power has attracted increasing attention as a renewable and clean energy.Gear fault frequently occurs under extreme environment and complex loads.The time-

期刊

windTURBINEPLANETARYgearTIME-VARYINGMESHINGSTIFFNESSdynamiccharacteristi

Lithium-ion full cell with high energy density using nickel-rich LiNi0.8Co0.1Mn0.1O2 cathode and SiO

A high-energy-density Li-ion battery with excellent rate capability and long cycle life was fabricated with a Ni-rich layered Li-Ni0.8Mn0.1Co0.1O2 cathode and S

期刊

HIGHenergydensityfullcellrateperformanceHIGHcapacityCATHODE

Effects of heat treatment on the intermetallic compounds and mechanical properties of the stainless

The effects of heat treatment on the microstructure and mechanical properties of intermetallic compounds in the interface of stainless steel 321 explosively bon

期刊

INTERMETALLICcompoundsEXPLOSIVEWELDINGheattreatmentstand-offDISTANCEMECH

Microstructure and corrosion behavior of AI3Ti/ADC12 composite modified with Sr

期刊

腐蚀行为合成SR微观结构电子显微镜修改边界一致腐蚀电流Sr modificationA13Ti/ADC 12 compositemicros

Improvement of microstructure and corrosion properties of friction stir welded AA5754 by adding Zn i

This study investigated the effect of Zn foil layers on the microstructure and corrosion characteristics of friction stir welded aluminum alloy 5754.Samples of

期刊

FRICTIONSTIRweldingAA5754aluminumalloyzincINTERLAYERMICROSTRUCTURECORRO

Microstructure refinement and work hardening in a machined surface layer induced by turning Inconel

The microstructural changes in the machined surface layer of Ni-based super alloys essentially determine the final performance of the structural components of a

期刊

grainREFINEMENTdislocation–twininteractionworkHARDENINGTURNINGINCONEL718

Microstructure characteristics of Ni/WC composite cladding coatings

一个多层的钨碳化物粒子(WCp ) 增强了基于 Ni 的合金涂层用真空 cladding 技术在钢底层上被制作。涂层的形态学，微观结构，和形成机制在不同地区被学习并且讨论。微观结构形态

期刊

镍基合金涂层复合涂层碳化钨颗粒组织形貌X射线衍射仪特征三维网状结构显微硬度cladding composite coatings microst