本文介绍一种在 单件生产中用一般滚 齿机铣长花键的方 法。如图所示,工件 (花键轴)的一端插入 工作台的中心孔内。 法兰套③其内径正好 能使工件穿过,在套 的圆柱部分沿径向加 工出四个直径为13 mm的等距螺孔,并 把装螺帽的部位铣 平,装上定位螺钉 ②,再在法兰盘上钻 三个孔, This article presents a method of milling long splines using a hobbing machine in a single part. As shown, one end of the workpiece (spline shaft) is inserted into the center hole of the table. Flange sleeve ③ The inner diameter of the workpiece is just enough to pass through. In the cylindrical part of the sleeve, four equidistant screw holes with a diameter of 13 mm are machined in the radial direction and the mounting screw holes are flattened. , Then drill three holes in the flange,