地表反照率对天空偏振模式的影响

来源 :光学学报 | 被引量 : 0次 | 上传用户：jurenyaoyao

【摘要】

：

研究了地表反照率对天空偏振模式的影响.针对目前缺乏实际环境下不同时间、不同地点单一影响因素的定量测试研究,先运用libRadtran二次开发软件,仿真分析不同地表反照率下的天空偏振模式,然后利用图像式测试系统,分别在草地和沥青地表、海洋和沥青地表进行同步异地测试,定量分析地表反照率对偏振方位角和偏振度的影响.结果表明:地表反照率对偏振方位角分布基本没有影响,分布始终稳定;而地表反照率对偏振度数值有较大的衰减作用,在同一天内同一时刻下,地表反照率越大,最大偏振度值越小;地表反照率相差越大,最大偏振度值的平

【作者】

：

崔岩刘亚飞刘康褚金奎

【机构】

：

大连理工大学精密与特种加工教育部重点实验室,辽宁大连116024

【出处】

：

光学学报

【发表日期】

：

2021年17期

【关键词】

：

大气光学地表反照率 libRadtran 定量测试最大偏振度值

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

其他文献

Static and Dynamic Analysis of a Piezoelectric Semiconductor Cantilever Under Consideration of Flexo

In this work,the static and dynamic response of a piezoelectric semiconductor can-tilever under the transverse end force with consideration of flexoelectricity and strain gradient elasticity is systematically investigated.The one-dimensional governing equ

期刊

Piezoelectric semiconductorFlexoelectricityStrain gradient elasticity

A Novel Fractional Plastic Damage Model for Quasi-brittle Materials

In this work,a novel constitutive model is developed within the framework of fractional plasticity to delineate the coupling between inelastic deformation and damage of quasi-brittle materials.Faced with the common challenge of determining plastic flow di

期刊

Quasi-brittle materialsFractional plasticityDamageDilatancyNumerical algorit

Fatigue Life of a 2.5D C/SiC Composite Under Tension-Tension Cyclic Loading:Experimental Investigati

Engineering structures made of ceramic matrix composites(CMCs)usually suffer from cyclic loads during service,which could lead to disastrous failures.This work focuses on the fatigue behavior of a 2.5D C/SiC composite under tension-tension cyclic loading.

期刊

Ceramic matrix composites(CMCs)2.5D C/SiC compositeFatigueMechanical properti

A Modified Elastoplastic Contact Stiffness Model Considering Continuous Smooth Contact Characteristi

The contact stiffness of the joint surface directly affects the static and dynamic mechanical behavior,and accuracy of the machine tool.A new elastoplastic contact stiffness model is proposed by considering continuous and smooth contact characteristics an

期刊

Joint surfaceContact stiffnessContinuous smooth contact characteristicsSub-st

Wavelet-Based Boundary Element Method for Calculating the Band Structures of Two-Dimensional Phononi

A wavelet-based boundary element method is employed to calculate the band struc-tures of two-dimensional phononic crystals,which are composed of square or triangular lattices with scatterers of arbitrary cross sections.With the aid of structural periodici

期刊

Wavelet-based boundary element methodB-spline wavelet on the intervalPhononic

A New Hybrid Stress Element with Fluid

In the process of shale gas exploitation,there exits two difficult problems:one is the real numerical simulation of a tremendous number of holes in actual shale;the other is the fluid-solid coupling problem involved in holes,where the difficulty of transi

期刊

Solid with fluidHybrid stress elementShale gas exploitationEulerian gridLagr

An Analysis of Piezomagnetic-Piezoelectric Semiconductor Unimorphs in Coupled Bending and Extension

We study the response of a composite beam(unimorph)with a piezomagnetic layer and a piezoelectric semiconductor layer under a transverse magnetic field.A one-dimensional model for coupled bending and extension of the beam is derived from the three-dimensi

期刊

PiezomagneticPiezoelectricSemiconductorUnimorph

Structure Design and Energy Absorption Mechanism of a New Type of Armor Inspired from Armadillos

Dermal armor,such as fish scales or armadillo osteoderms,has been known to exhibit high performance and good flexibility defending against attack.The top layer of the dermal armor usually consists of a segmented hard bony layer.The soft inner layer compos

期刊

BioinspiredArmorImpactEnergy absorptionNumerical simulation

Geometrically Nonlinear Topology Optimization of Continuum Structures Based on an Independent Contin

A geometrically nonlinear topology optimization method for continuum structures is proposed based on the independent continuous mapping method.The stress constraint problem is studied due to the importance of structural strength in engineering application

期刊

Topology optimizationGeometric nonlinearityICM methodStress constraintsStres

基于NRZ+Manchester信号和偏振复用的无源光互连数据中心

无源光互连数据中心由于其低成本、低功耗和高速率受到了广泛关注.在无源光互连数据中心中,同时可用的信道数目不能超过可用波长数,波长数量也限制了总吞吐量.为了减少光互连数据中心的波长需求、提高光互连数据中心的波长利用率与可扩展性,将NRZ+ Manchester信号结合偏振复用应用于光互连数据中心,实现机架内4个服务器共享一条波长,从而将吞吐量提升4倍.通过仿真验证了该方案在10 Gbit/s速率下能够只使用16个波长实现机架内64个服务器的光互连,在25 Gbit/s速率下只使用8个波长就能够实现32个服务

期刊

光通信光互连数据中心偏振复用叠加信号无源光互连

地表反照率对天空偏振模式的影响

与本文相关的学术论文