论文部分内容阅读
An NM400 wear-resistant steel was hot rolled and then the plates were heat-treated by direct quenching and tempering (DQT) and reheat quenching and tempering (RQT) techniques,respectively.The Charpy impact test was carried out with an instrumented Charpy impact tester.The microstructure and fracture surface were investigated by a combination of optical microscopy,transmission electron microscopy and scanning electron microscopy methods.It was found that the impact toughness of DQT specimen was much higher than that of RQT specimen.The microstructure of both DQT and RQT specimens was characterized by a mixture of tempered lath martensite and lower bainite.The lower bainite in DQT specimen extended into prior austenite grains and the content was higher than that in RQT specimen.The lower bainite in DQT specimen improved the impact toughness by increasing the proportion of large-angle boundaries and relieving the stress concentration at the crack tip.A number of fine and dispersed carbides in DQT specimen also contributed to the improvement of the impact toughness.
An NM400 wear-resistant steel was hot rolled and then the plates were heat-treated by direct quenching and tempering (DQT) and reheat quenching and tempering (RQT) techniques, respectively. The Charpy impact test was carried out with an instrumented Charpy impact tester .The microstructure and fracture surface were investigated by a combination of optical microscopy, transmission electron microscopy and scanning electron microscopy methods. It was found that the impact toughness of DQT specimen was much higher than that of RQT specimen. Microstructure of both DQT and RQT specimens was characterized by a mixture of tempered lath martensite and lower bainite. the lower bainite in DQT specimen extended into prior austenite grains and the content was higher than that in RQT specimen. the lower bainite in DQT specimen improved the impact toughness by increasing the proportion of large-angle boundaries and relieving the stress concentration at the crack tip. A number of fine and dispersed carbide s in DQT specimen also contributed to the improvement of the impact toughness.