Stability of liquid crystal systems doped with γ-Fe2O3 nanoparticles

来源 :中国物理B(英文版) | 被引量 : 0次 | 上传用户:mqzhen1987
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
In order to explore the stability of a liquid crystal (LC) system doped with γ-Fe2O3 nanoparticles,the physical properties (clearing point,dielectric properties),electro-optical properties and residual direct-current voltage (RDCV) of the doped LC system were measured and evaluated at different times.First,the temperature was controlled by precision hot stage,and the clearing point temperature of doped LC was observed and measured by a polarized optical microscope.Using a precision LCR meter,we measured the capacitance-voltage curves of the doped LC system at the temperature of 27 ℃.The dielectric constant of doped LC was calculated by the dualcell capacitance method.Then,the electro-optical properties of the doped LC system were measured.Finally,the RDCV of the doped LC system was measured and calculated.After five months,the parameters of the doped LC system were re-measured and analyzed under the same conditions to evaluate its stability.The experimental results show that,within five months,the clearing point change rate of doped LC is in the range of 0.24%-1.37%,the change of dielectric anisotropy is in the range of 0.035-0.2,the curves of electro-optical properties are basically fitted,and the change rate of saturated RDCV is about 11.2%,which basically indicate that the LC system doped with γ-Fe2O3 nanoparticles has good stability.
其他文献
Using hybrid density functional calculation,we study the atomic and electronic structures of p-type dopants,B,A1 and Ga,in 4H-SiC.For B,depending on the growth condition,it can occupy both Si and C sites.In contrast,A1 and Ga on the C sites exhibit too hi
A1GaN/GaN high-electron-mobility transistors with Au-free ohmic contacts are fabricated by selective laser annealing and conventional rapid thermal annealing.The current transport mechanism of ohmic contacts is investigated.High-temperature annealing can
Damage depth is an important dynamic parameter for describing the degree of material damage and is also a key fundamental issue in the field of impact compression technology.The present work is dedicated to the damage depth of shock-melted metal in micros
We report the strong dependence of resistance on uniaxial strain in monolayer WSe2 at various temperatures,where the gauge factor can reach as large as 2400.The observation of strain-dependent resistance and giant gauge factor is attributed to the emergen
The low-temperature magnetic order behaviors of perovskite oxide CaCu3Ti4O12 (CCTO) ceramics prepared by dif-ferent methods are discussed.X-ray diffraction,scanning electron microscope,x-ray photoelectron spectroscopy,and direct current (DC) magnetization
The operating frequencies of surface plasmons in pristine graphene lie in the terahertz and infrared spectral range,which limits their utilization.Here,the high-frequency plasmons in doped graphene nanostructures are studied by the time-dependent density
We investigate the spin-related currents and tunnel magnetoresistance through a quantum dot,which is side-coupled with a Majorana fermion zero mode and two thermal-driven ferromagnetic electrodes.It is found that the interplay of Majorana fermion and elec
To study the electron transport properties in InGaN channel-based heterostructures,a revised Fang-Howard wave function is proposed by combining the effect of GaN back barrier.Various scattering mechanisms,such as dislocation impurity (DIS) scattering,pola
Strontium titanate (SrTiO3) is a thermoelectric material with large Seebeck coefficient that has potential applications in high-temperature power generators.To simultaneously achieve a low thermal conductivity and high electrical conduc-tivity,polycrystal
We perform first-principles calculations and coherent laser-matter interaction analyses to investigate the laser-induced ultrafast spin flip on graphene nanoflakes (GNFs) with transition metal elements attached on the boundary[TM&GNFs(TM =Fe,Co,Ni)].It is