试验以18年生六号李结果树的半木质化绿枝为试材,将其截成长12cm左右的插条,保留上部3～4片叶。于6月初扦插,插前将插条基部在ABT生根粉100ppm溶液中浸渍45分钟,或分别在吲哚乙酸(IAA)和萘乙酸(NAA)1000ppm、500ppm和250ppm溶液中速蘸5秒钟,以浸清水为对照。采用电热温床和塑料小棚,保持基质温度25～30℃,相对湿度在95％以上。试验结果表明:以ABT生根粉处理的效果最好,能促进插条切口 The experiment was based on the semi-lignified green branches of 18-year-old No.6 Li tree, cut the cuttings about 12cm long, and kept the upper 3 ~ 4 leaves. In early June, the cuttings were immersed in 100ppm ABT rooting solution for 45 minutes before plugging, or dipped in 1000ppm, 500ppm and 250ppm solutions of indole acetic acid (IAA) and naphthaleneacetic acid (NAA) respectively for 5 seconds, To dipping water as a control. Using electric hotbed and plastic shed, to maintain the substrate temperature 25 ~ 30 ℃, relative humidity above 95%. The experimental results show that: ABT rooting powder treatment is the best, can promote cuttings