【摘 要】
：
In the background of the technology condition and the geological condition of the 1151(3) fully mechanized top-coal caving face (FMTC face), and by means of taking nonlinear 3D numerical simulation, the stress redistribution rules of top coal with differe
【机 构】
：
Department of Resources Exploration and Management Engineering, Anhui University of Science and Tech
论文部分内容阅读
In the background of the technology condition and the geological condition of the 1151(3) fully mechanized top-coal caving face (FMTC face), and by means of taking nonlinear 3D numerical simulation, the stress redistribution rules of top coal with different thick coal seam were obtained by investigation on the numerical simulation of the redistributions of the stress with different coal seam\'s thickness. The research showes that there exists a certain difference on the stress distributions of the top coal at face, the maximum principal stress is located near to the tailentry\'s corner. The vertical stress\'s peak of the top coal decreases and the distance ahead of face position increases as the once mining thickness of the coal seam increases. At the same coal seam, the vertical stresses\' peak of top coal gradually decreases from the top to the bottom, the peak\'s position is basically the same and its changes are gradually obvious with the thickness of coal seam increasing. The vertical stress of top coal places in a low stress state at a certain range ahead of face and over the face, which reveals the essence that the support loads are generally low under the condition of FMTC. The study supplies the theoretical foundation for the support design and selection, the theory of top coal\'s fragmentation, the movement rules of top coal and improving the recovery of top coal.
其他文献
Presented a new coal dust control program that was airtight negative pressure dust-control technology at the transpersite,combining with analysis with the movement of air currents and numerical simulation of gas-solid flow at the transpersite,and proved t
With FLAC,a criteria of stress release ratio(SRR),i.e.,about 10% of the relative difference of the ground settlement before and after the supporting system is installed,is incorporated into stress release method(SRM).At the same time,the Mohr-Coulomb Crit
Based on the open stope method, the stability of the gob area was decided by pillars and stiff roof. Therefore, it was dispensable to leave pillars with long-term strength and enough size to support the stiff roof during mining activities. Based on the mi
The mechanical principle and surrounding rock deformation feature of high stress coal roadway was analyzed. The condition of stress balance of the kind of the roadway was put forward. The surrounding rock control principle and supporting technique of high
The artificial neutral network(ANN) has the ability that self-study and self-remember, its 3 layers BP network has been applied extensively, but sometimes because of serious multi-correlation between the variables, and a few observations while many variab
The impact on these water bodies of the surrounding coal production activities and the power plant through research the content and characteristics of harmful trace elements in coal contained in these water bodies. F, Hg, Se and As these four trace ele-me
According to the characteristic of clay aquiclude of overburden, the propersimulation materials and proportions of mixture for simulating the plastic clay aquicludelayers were developed, and the plastic similarity conditions were setup. Thus, the simili-t
The main purpose of the research is to discuss the influence on ground water by NH4-N in polluted river and river bed. In the lab-scale experiment three kinds of natural sand were chosen as infiltration medium, and polluted rivers were simulated by domest