在装侧置发动机气门弹簧时,如果一时没有气门弹簧钳,怎么办呢?不用愁,用下列方法也可按装。用一根长80cm的细铁丝弯成“O”型和一把中号开口起子,两人协助操作。具体方法是:一人先用预先弯好的“O”型细铁丝从气门导管的上口向下伸入许多,另外一人把气门弹簧,座圈穿在铁丝上,弹簧上端对准导管,起子放在座圈下端并伸在“O”型 In the side mounted engine valve spring, if you do not have a valve spring clamp, how do? Do not worry, can also be installed by the following method. Use a long 80cm thin iron wire bent into “O” type and a medium open screwdriver, two people assist in the operation. The specific method is: one with a pre-bent good “O” type fine wire down from the mouth of the valve guide down a lot, the other one to the valve spring, seat wear wire in the wire, the spring at the top of the catheter alignment, screwdriver At the bottom of the seat and stretch in the “O” type