起动开关——控制发动机起动及除去蓄电池、起动机、车厢灯和停车灯以外的所有电路。起动开关可分如下几个动作: 1.开关钥匙在图3-1的位置时才能插入或拔出。此时,除蓄电池、起动机、车厢灯、停车灯(兼做尾灯)外,其它所有电路完全关断。 2.将开钥匙转向右方一挡(图3—2)时,则除了予热电路、起动电路以外的所有电路接通,油压报警灯、充电指示灯、真空报警灯同时发亮。在行驶时,开关钥匙必须插入此位置。 3.将开关再向右转到二挡(图3—3),则立即接通起动电路,起动机便开始运转, Start Switch - Controls engine start-up and removal of all circuitry except batteries, starter, compartment lights, and stop lights. Start switch can be divided into the following several actions: 1. The switch key in Figure 3-1 position can be inserted or pulled out. At this point, in addition to batteries, starter, compartment lights, stop lights (also taillights), all other circuits completely shut down. 2. Turn the key to the right of the first block (Figure 3-2), then in addition to the preheating circuit, the starting circuit is connected to all circuits, hydraulic alarm lights, charging lights, vacuum alarm lights at the same time. When driving, the key must be inserted in this position. 3. Turn the switch to the right again to the second gear (Figure 3-3), then immediately start the circuit, the starter will start running,