【摘 要】
：
To improve the accuracy of color image reproduction from displays to printers, an adaptively spatial color gamut mapping algorithm (ASCGMA) is proposed. In this algorithm, the compression degree of out-of-reproduction-gamut color is not only related to th
【机 构】
：
StateKeyLaboratoryofModernOpticalInstrumentation,ZhejiangUniversity,Hangzhou310027,China
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
To improve the accuracy of color image reproduction from displays to printers, an adaptively spatial color gamut mapping algorithm (ASCGMA) is proposed. In this algorithm, the compression degree of out-of-reproduction-gamut color is not only related to the position of the color in CIELCH color space, but also depending on the neighborhood of the color to be mapped. The psychophysical experiment of pair comparison is carried out to evaluate and compare this new algorithm with the HPMINDE and SGCK gamut mapping algorithms recommended by the International Commission on Illumination (CIE). The experimental results indicate that the proposed algorithm outperforms the algorithms of HPMINDE and SGCK except for the very dark images.
其他文献
Intrinsic zinc oxide films, normally deposited by radio frequency (RF) sputtering, are fabricated by direct current (DC) sputtering. The oxygen-deficient targets are prepared via a newly developed double crucible method. The 800-nm-thick film obtaines sig
基于双轴跟踪槽式聚光系统设计了焦面能流密度测试装置,采用理论分析和实验测试的方法对由接收器的定位误差和跟踪误差引起的聚焦损失进行研究,并通过采集因子量化光学损失,从而揭示出各种误差影响的规律。结果表明:随着定位误差的增大,焦面宽度增加,焦面能流密度降低且趋于均匀;随着跟踪误差角的增大,焦面中心偏移量和光学损失增加。对于实验使用的双轴跟踪槽式聚光系统,当接收器光孔宽度为50 mm时,若要保证采集因子大于90%,接收器的定位误差需保证在455 mm的±1.1%之间且跟踪误差角小于0.111°,此时采集因子可达
We demonstrate an efficient tunable diode-end-pumped continuous wave (CW) Yb3 :Lu2SiO5 (Yb:LSO) laser. With a 5 at.-% Yb3 -doped sample, we obtained 3.24-W output at 1080 nm for 7.3 W of absorbed pump power, the corresponding slope efficiency was 55%. And
An optical fiber extrinsic Fabry–Perot interferometer (EFPI) is designed and fabricated for refractive index (RI) sensing. To test the RI of liquid, the following two different methods are adopted: the wavelength tracking method and the Fourier-transform
热释电传感器用于红外目标跟踪,可以通过光学调制探测到运动目标的相对方向,而不能确定其准确距离,对此提出一种群智能搜索的动态热释电跟踪方法。传感器在摆动状态下感知红外目标,发现目标时,记录其探测角,通过分析探测角序列与运动目标轨迹离散点在极坐标系下的关系,将目标轨迹的确定转化为极径序列的确定,然后建立关于极径序列的多维粒子群空间,并构造评价粒子优劣的适应度函数,实现了运动目标轨迹的跟踪。该方法扩大了
光计算，其运算速度比高速子弹还快，其威力比机车还大，一次能处理充满一幢高层建筑的数据。遗憾的是，它至今还未变成现实，还不能拯救电子计算机遇到难关的领域。困难几乎如你所想象的，超级计算机——即光学计算机几乎完全仍是梦想。
S变换具有时频分析能力和多分辨率特点,可以看作是窗口傅里叶变换和小波变换的扩展。S变换不仅克服了傅里叶变换缺乏局部分析能力的不足,其变换系数又与待分析图像的傅里叶谱之间存在紧密联系,近年来被应用于条纹分析中。根据S变换系数的特点,深入研究了基于二维S变换的"脊"(2DSTR)分析方法和二维S变换"滤波"(2DSTF)分析方法,并对两种方法进行了详细对比。计算机模拟和实验验证了理论分析结果,研究结果
By using silicon-on-insulator (SOI) platform, 12 channel waveguides, and four parallel-coupling one-microring resonator routing elements, a non-blocking four-port optical router is proposed. Structure design and optimization are performed on the routing e
测量了一种绿色和红色CdSe/ZnS量子点/硅胶复合薄膜的吸收光谱和光致发光光谱。结果表明,量子点薄膜在不同的激发波长下,拥有稳定的光致发光光谱,峰值波长分别为527 nm和628 nm。将量子点/硅胶复合薄膜与YAG∶Ce 3 黄色荧光粉结合,制备了两种不同结构的白色发光二极管(WLED),测量了其在不同驱动电流下的光学性能和表面温度。在350 mA的驱动电流下,Ⅱ号WLED的表面温度比Ⅰ号WLED低26.5 ℃。在55 ℃温度和55%相对湿度条件下进行老化实验。结果表明,在不同的驱动电流下两种WLED
A low-loss hybrid plasmonic transverse magnetic (TM)-pass polarizer has been demonstrated utilizing polarization-dependent mode conversion. Taking advantage of the silicon hybrid plasmonic slot waveguide (HPSW), the unwanted transverse electric (TE) funda