论文部分内容阅读
The wear-resistant tin bronze (Cu-10Sn-4Ni-3Pb) with tin content above 8 wt.% prepared by traditional melting and casting process usually defects such as low density, poor properties and segregations. The crystallization under pressure processing of Cu-10Sn-4Ni-3Pb alloy was investigated. The microstructures were observed and analyzed and compared with that by traditional melting and casting process. The results show that the dendrite has obviously disappeared and the dendritic segregation alleviated by using the crystallization under 680 MPa pressure process, in comparison with the remarkably dendrite microstructure and severe as-cast defects of alloy prepared by traditional melting and casting technology. Based on the experimental study, the properties and microstructures of Cu-10Sn-4Ni-3Pb tin bronze prepared by crystallization under pressure have been improved significantly.
The wear-resistant tin bronze (Cu-10Sn-4Ni-3Pb) with tin content above 8 wt.% Prepared by the conventional melting and casting process usually defects such as low density, poor properties and segregations. The crystallization under pressure processing of Cu- The results show that the dendrite has apparently disappeared and the dendritic segregation alleviated by using the crystallization under 680 MPa pressure process, based on the experimental study, the properties and microstructures of Cu-10Sn-4Ni-3Pb tin bronze prepared by crystallization under pressure have been improved significantly.