基于Cooja的SD-IoT仿真实验平台的设计与实现

来源 :内蒙古科技大学学报 | 被引量 : 0次 | 上传用户：gundamchen

【摘要】

：

软件定义网络是最近出现的一种新范式,它通过将所有控制和管理操作从底层设备中抽象出来,并将其设置在软件层中,从而隐藏了传统网络架构中的所有复杂性.搭建软件定义物联网(SD-IoT)仿真实验平台格外重要,现在大多采用基于开源工具搭建开发环境设计应用系统,这种方法对于新学者并不友好.文章详细地介绍了SD-IoT仿真实验平台的搭建过程,以及用实例来验证平台的可靠性.

【作者】

：

孙涛蔡江涛

【机构】

：

内蒙古科技大学信息工程学院,内蒙古包头 014010

【出处】

：

内蒙古科技大学学报

【发表日期】

：

2021年4期

【关键词】

：

Cooja Contiki OS SD-IoT 仿真平台设计

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

其他文献

Petroleum coke as reductant in co-reduction of low-grade laterite ore and red mud to prepare ferroni

Petroleum coke is industrial solid wastes and its disposal and storage has been a great challenge to the environment. In this study, petroleum coke was utilized as a novel co-reduction reductant of low-grade laterite ore and red mud. A ferronickel product

期刊

petroleum cokeferronickelco-reductionsolid waste utilization

Electrochemical process for recovery of metallic Mn from waste LiMn2O4-based Li-ion batteries in NaC

A new method is proposed for the recovery of Mn via the direct electrochemical reduction of LiMn2O4 from the waste of lithium-ion batteries in NaCl?CaCl2 melts at 750℃. The results show that the LiMn2O4 reduction process by the electrochemical method on t

期刊

lithium-ion-battery wasteelectrochemistry of meltsMn recoveryelectro-deoxidat

U(VI) adsorption behavior onto polypyrrole coated 3R-MoS2 nanosheets prepared with the molten salt e

To improve the separation capacity of uranium in aqueous solutions, 3R-MoS2 nanosheets were prepared with molten salt electro-lysis and further modified with polypyrrole (PPy) to synthesize a hybrid nanoadsorbent (PPy/3R-MoS2). The preparation conditions

期刊

molten salt electrolysis3R-MoS2 nanosheetspolypyrrole modificationadsorption

Effect of extrusion process on microstructure and mechanical and corrosion properties of biodegradab

The effect of extrusion temperature and ratio on the microstructure, hardness, compression, and corrosion behavior of Mg–5Zn–1.5Y alloy were analyzed in this study. The microstructural observations revealed that the cast alloy consists of α-Mg grains, and

期刊

magnesium?alloybiodegradableextrusionmicrostructuremechanical?propertiescor

Three-dimensional graphitic carbon sphere foams as sorbents for cleaning oil spills

Frequent offshore oil spill accidents, industrial oily sewage, and the indiscriminate disposal of urban oily sewage have caused seri-ous impacts on the human living environment and health. The traditional oil–water separation methods not only cause easily

期刊

graphitic carbon spheresthree dimensionalfoamsgel castingoil adsorption

Multicomponent transition metal phosphide for oxygen evolution

Transition metal phosphides (TMPs) have exhibited decent performance in an oxygen evolution reaction (OER), which is a kinetic bottleneck in many energy storages and conversion systems. Most reported catalysts are composed of three or fewer metallic compo

期刊

multicomponent?transition?metal?phosphideselectrocatalytic?oxygen?evolution?rea

Preparation and oxidation characteristics of ZrC–ZrB2 composite powders with different proportions

ZrC and ZrB2 are both typical ultra-high temperature ceramics, which can be used in the hyperthermal environment. In this study, a method for preparing ultrafine ZrC–ZrB2 composite powder was provided, by using the raw materials of nano ZrO2, carbon black

期刊

boridescarbidescore-shell structurespowdersultra-high temperature ceramic

Titanium dioxide-graphene composite electrochemical sensor for detection of hexavalent chromium

Hexavalent chromium (Cr(VI)) compound is useful to various industries but is toxic and carcinogenic. In this research work, we fab-ricate an amperometric sensor for the determination of Cr(VI), using a titanium dioxide (TiO2)-reduced graphene oxide (rGO)

期刊

photocatalystelectrochemical sensorhexavalent chromiumgraphene

Combining the 8-hydroxyquinoline intercalated layered double hydroxide film and sol–gel coating for

8-hydroxyquinoline (8-HQ) intercalated layered double hydroxides (LDH) film as underlayer and sol–gel layer was combined for active corrosion protection of the AM60B magnesium alloy. The LDH, LDH/sol–gel, and LDH@HQ/sol–gel coatings were analyzed using th

期刊

magnesium alloysol–gellayered double hydroxidescorrosioncoating

In situ carbon coating for enhanced chemical stability of copper nanowires

Copper nanowires (CuNWs) are promising electrode materials, especially for used in flexible and transparent electrodes, due to their advantages of earth-abundant, low-cost, high conductivity and flexibility. However, the poor stability of CuNWs against ox

期刊

electrode materialcopper nanowirein situ carbon coatingstability

基于Cooja的SD-IoT仿真实验平台的设计与实现

与本文相关的学术论文