论文部分内容阅读
机器液压系统中常用形状复杂多通管接头,其品种繁多。为缩短生产准备周期,我厂设计制造了加工多通管接头用车夹具。 1.夹具结构夹具(见图)通过法兰盘10安装在车床主轴上。圆盘1上装有丝杠8带动的左夹头4及右夹头7。夹板2和导板3以夹头的宽度定位组成T形槽;以圆柱销13定位,用螺钉12固定在圆盘1上。用U形槽支承丝杠8。环槽外圆的卡块9通过导槽中心安装在圆盘1上。可换护口片以φ24h6外圆定位用螺钉11固定在夹头上。可换护
Commonly used in the hydraulic system of complex multi-way pipe fittings, a wide variety. In order to shorten the production preparation cycle, I design and manufacture of the factory processing multi-pass connector car fixture. 1. Fixture Structure Fixture (see picture) is installed on the lathe spindle through flange 10. The disk 1 is equipped with a left chuck 4 and a right chuck 7 driven by a screw 8. Plywood 2 and the guide plate 3 to the width of the chuck positioning T-shaped groove; cylindrical pin 13 positioning, with a screw 12 is fixed to the disc 1. U-shaped groove with the support screw 8. The snap block 9 on the outer periphery of the ring groove is mounted on the disk 1 through the center of the guide groove. Can be changed to tablets φ24h6 cylindrical positioning with screws 11 is fixed on the chuck. Can be changed