论文部分内容阅读
图1为国内通用的弹压卸料装置,该装置在更换易损件、刃磨刀口、调整模具时,都必须将整个模具从冲床上搬下来,很不方便。近期,我们设计成功一种新的弹压卸料装置如图2所示,已投入生产,效果良好。图中左面部分可用于卸料力较小的场合,螺钉2拧紧在卸料板3上,右面部分适用于卸料力较大的情况;螺钉2与卸料板无配合要求。当需要对模具零件进行检修、调整或更换
Figure 1 for the domestic pop-up unloading device, the device in the replacement of wearing parts, sharpening shank, adjust the mold, the entire mold must be removed from the punch, very inconvenient. Recently, we successfully designed a new type of ejector device shown in Figure 2, has been put into production, the effect is good. The left part of the figure can be used for the occasions where the unloading force is small, the screw 2 is tightened on the stripper plate 3, and the right part is suitable for the case that the unloading force is relatively large; the screw 2 and the stripper plate have no requirements. When the need for mold parts for repair, adjustment or replacement