板条切断器我厂自由锻的板条毛坯大部是5～16个件连在一起的,锻完后再用剁刀切开。由于毛坯太薄(5～13毫米),这样切断一方面生产效率很低并易把剁刀打坏,造成事故;另一方面对设备也有损害。为克服以上缺点,我厂老师傅革新成切断器。当毛坯的切断尺寸相同时,可用图1的切断器,因L_1等于L_2,一次可切断两 Slat Cutter Our factory forged blank slabs are mostly 5 to 16 pieces together, forging and then cut with a chop knife. As the blank is too thin (5 ~ 13 mm), this cut-off on the one hand low production efficiency and easy to chop chopper damage, resulting in accidents; the other hand, the equipment is also damaged. In order to overcome the above shortcomings, our factory master reform into a cut off device. When the blank cut off the same size, the cutter can be used in Figure 1, because L_1 is equal to L_2, one can cut off two