本文研究了制坯辊锻工艺及模具的计算机辅助设计通用程序。着重探讨了锻件几何形状与尺寸的描述,简化锻件截面图来确定辊锻毛坯,辊锻道次数与型槽系的选择,对辊锻过程中压下、宽展、前滑等变形参数计算方法的探讨,设计中所用图表曲线的公式化等问题。在此基础上概述了已编制的通用程序,并以某连杆锻件为例给出了在计算机上得出的设计结果。 This article studies the blank roll forging process and the mold computer aided design general procedure. The paper mainly discusses the geometry and size of the forgings, simplifies the cross-section of the forgings to determine the number of roll forging blanks, the number of roll forges and the choice of groove system. The calculation methods of the deformation parameters such as pressure, The design, the curve used in the design of the formula and other issues. On this basis, the general program has been outlined, and the design results obtained on the computer are given by taking a connecting rod forgings as an example.