【摘 要】
：
Effect of annealing temperature and time on the microstructure and photoluminescence (PL) properties of Al doped ZnO thin films deposited on Si (100) substrates
【机 构】
：
School of Microelectronics and Solid-State Electronics
论文部分内容阅读
Effect of annealing temperature and time on the microstructure and photoluminescence (PL) properties of Al doped ZnO thin films deposited on Si (100) substrates by sol-gel method was investigated. An X-ray diffraction (XRD) was used to analyze the structural properties of the thin films. All the thin films have a preferential c-axis orientation, which are enhances in the annealing process. It is found from the PL measurement that near band edge (NBE) emission and deep-level (DL) emissions are observed in as-grown ZnO∶Al thin films. However, the intensity of DLE is much smaller than that of NBE. Enhancement of NBE is clearly observed after thermal annealing in air and the intensity of NBE increases with annealing temperature. Results also show that the PL spectrum is dependent not only on the processing temperature but also on the processing time. The DLE related defects can not be removed by annealing, and on the contrary, the annealing conditions actually favor their formation.
其他文献
The thermal stability, phase transformation, surface morphology, pore size distribution and permeation of the defect-free silica-zirconia membrane were investig
A rapid method for the determination of impurity elements, such as Zn, Ni, Co, Cr, Cu, Cd and Pb in manganese tetroxide was developed, using inductively coupled
The nickel electroplating process was investigated by means of electrochemical noise(EN), cyclic voltammetry in conjunction with the scanning electron microscop
V2O5 nanotube arrays in porous anodic alumina ( PAA ) template were obtained from V2 O5sols prepared by melt quenching method.X-ray powder diffraction and selec
Plasma carburization at two different methane-to-argon gas ratios (5:5 and 6:5) was carried out on the cast TiAl based alloy of Ti-46.5Al-2.5V-1Cr (mole fractio
Rare earth mineral composite materials were prepared using rare earths and natural far-infrared mineral materials. The influences of rare earth additive content
Resins of complexes made from agarose-Ce4+ (RCA-Ce) and chitosan-Ce4+ (RCC-Ce) were prepared. Hydrolysis rates of methamidophos, omethoate and chlorpyrifos trea
Oxygen precipitates in heavily Sb-doped silicon after rapid thermal process (RTP) in Ar ambient were investigated by RTP at high temperature following annealing
Y1.94-xMgxO2S:0.06Ti (0≤x≤0.10) phosphors with long afterglow were synthesized by solid state reaction route. The photoluminescence spectra, decay curves, the
The effect of reinforcement on the solidification of pure metal matrix composites (MMCs) was simulated using a two-dimensional solidification temperature field