论文部分内容阅读
瑞士克雷亚混凝土建材集团公司的SAMANTO商标是一种围墙和挡墙砌块的“代名词”。它实际上有两种规格的单孔型混凝土砌块(图1)——简称A块和B块,两种块型均可单一规格垒砌、也可两种块型“混合”垒砌(见图2),但是墙体的上下皮必须是同一种块型对应。B块外型为八角形,每一个边都可以与A块实现“互咬合”(见图3)。SAMANTO砌块的应用非常灵活,它可根据垒砌围墙的高度不同,选择在砌块孔洞内填充粗石子骨料或做配筋混凝土处理(见图4)。垒砌垂直挡土墙的最大高度为75cm,带坡度的挡土墙,则完全可根据工程设计来确定(见图5);也可以设计成护坡结构形式。在砌块孔洞内填种植土,可种植花草、小灌木等,挡土墙或围墙的绿化效
The SAMANTO ® trademark of Swiss Crenella Building Materials Group is a “synonym” of a wall and retaining wall block. It actually has two kinds of single-hole concrete block (Figure 1) - referred to as Block A and Block B, both block types can be a single specification barrier, but also two block type “mixed” base Laying (see Figure 2), but the wall of the upper and lower skin must be the same type of block correspondence. B block octagonal shape, each side can be achieved with A block “mutual bite ” (see Figure 3). The SAMANTO® block is flexible enough to be used to fill block holes with coarse gravel aggregates or reinforced concrete (see Figure 4), depending on the height of the barrier wall. The maximum vertical height of the reinforced concrete retaining wall is 75cm. The retaining wall with the slope can be completely determined according to the engineering design (see Figure 5). It can also be designed as a slope protection structure. Fill planting holes in the hole, planting flowers, shrubs, etc., retaining wall or wall greening effect